Fuel Priming Pump - Remove and Install
- Relieve fuel pressure by opening relief valve (3).
- Remove bolts (2).
- Remove fuel priming pump (1) and discard the gasket. Use a new gasket for installation.
Show/hide table
Personal injury or death can result from a fire. Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. Clean up all leaked or spilled fuel. Do not smoke while working on the fuel system. Turn the disconnect switch OFF or disconnect the battery when changing fuel filters. |
Show/hide table
Illustration 1 | g03056445 |
- Install fuel priming pump (1) in the reverse order of removal.
- Tighten bolts (2) to a torque of
25 ± 6 N·m (18 ± 4 lb ft) .
- Tighten bolts (2) to a torque of
Caterpillar Information System:
C1.5 and C2.2 Engines for Caterpillar Built Machines Clean Emissions Module
G3500 Engines Accessory Drive (Lower Left Hand)
2012/05/28 A New Console Harness Assembly Is Available for Certain Excavators {1408}
Repairing Line Relief Valve Seats in Hydraulic Control Valves Using the 229-3612 Hydraulic Valve Seat Repair Kit{0738, 5117} Repairing Line Relief Valve Seats in Hydraulic Control Valves Using the 229-3612 Hydraulic Valve Seat Repair Kit{0738, 5117}
C18 Marine Engines Electric Starting Motor - Remove and Install
C18 Marine Engines Alternator - Remove and Install
C18 Marine Engines Crankshaft - Remove and Install
C18 Marine Engines Crankshaft Main Bearings - Remove and Install
C18 Marine Engines Connecting Rod Bearings - Remove and Install
C7.1 Industrial Engine Monitoring System - Engine Indicators and Aftertreatment Indicators
C18 Marine Engines Pistons and Connecting Rods - Remove and Install
C18 Marine Engines Piston Cooling Jets - Remove and Install
C7.1 Industrial Engine Sensors and Electrical Components
C18 Marine Engines Fuel Filter Base - Remove and Install
C7.1-XQ200 Rental Generator Set Diesel Particulate Filter Regeneration
ES12F, UPS 1000S and UPS 1200S Uninterruptible Power Supplys Bearing (Earlier) - Replace
ES12F, UPS 1000S and UPS 1200S Uninterruptible Power Supplys Bearing (3.5 EVD or Greater) - Replace
UPS 120, UPS 150, UPS 250 and UPS 300 Uninterruptible Power Supplies Bearing (Earlier) - Replace
UPS 120, UPS 150, UPS 250 and UPS 300 Uninterruptible Power Supplies Bearing (3.5 EVD or Greater) - Replace
UPS 1000S and UPS 1200S Uninterruptible Power Supplys , Parallel Maintenance Interval Schedule
UPS 1000S and UPS 1200S Uninterruptible Power Supplys , Parallel Bearing (Earlier) - Replace
UPS 1000S and UPS 1200S Uninterruptible Power Supplys , Parallel Bearing (3.5 EVD or Greater) - Replace
LEM Failures On UPSB505 Uninterruptible Power Supply{4480} LEM Failures On UPSB505 Uninterruptible Power Supply{4480}
G3516C and G3516E Gas Engines Water Lines