Torque Converter
Show/hide table
 | |
| 图 1 | g02969997 |
Show/hide table
| 359-5445 变矩器总成 和 372-1068 变矩器总成 的技术规格 | |||
| 项目 | 数量 | 零件 | 技术规格说明 |
| 1 | 12 | 351-9430 螺栓 | 拧紧至扭矩为 50 ± 7 N·m (37 ± 5 lb ft)。 |
| 2 | 三块新摩擦片和两块新盘的厚度为 21.35 ± 0.34 mm (0.841 ± 0.013 in)。 |
||
| 3 | 336-9318 摩擦片 | 一块新摩擦片的厚度为 4.83 ± 0.08 mm (0.190 ± 0.003 in)。 |
|
| 2 | 1T-1897 盘 | 一块新盘的厚度为 3.43 ± 0.05 mm (0.135 ± 0.002 in)。 |
|
| 3 | 12 | 5P-2546 螺栓 | 拧紧至扭矩为 80 ± 10 N·m (59 ± 7 lb ft)。 |
| 4 | 1 | 281-0740 锁紧螺母 | 将 Loctite C5A 铜防粘结剂涂抹在锁紧螺母的螺纹和表面上。 拧紧至扭矩为 205 ± 15 N·m (151 ± 11 lb ft)。 |
| 5 | 3 | 9X-8873 螺栓 | 拧紧至扭矩为 120 ± 15 N·m (89 ± 11 lb ft)。 |
| 6 | 11 | 3B-1915 螺栓 | 拧紧至扭矩为 50 ± 7 N·m (37 ± 5 lb ft)。 |
| 7 | 8 | 1T-0720 螺栓 | 拧紧至扭矩为 50 ± 7 N·m (37 ± 5 lb ft)。 |
| 8 | 6 | 2B-2695 螺栓 | 拧紧至扭矩为 30 ± 5 N·m (266 ± 44 lb in)。 |
| 9 | 16 | 0S-1587 螺栓 | 拧紧至扭矩为 120 ± 15 N·m (89 ± 11 lb ft)。 |
| 10 | 2 | 1T-1257 弹簧 | 在试验力下的长度为 17.78 mm (0.700 in)。 |
| 试验力为 30.74 ± 1.96 N (6.91 ± 0.44 lb)。 |
|||
| 试验后的自由长度为 27.43 mm (1.080 in)。 |
|||
| 11 | 24 | 9X-8880 螺栓 | 拧紧至扭矩为 240 ± 25 N·m (177 ± 18 lb ft)。 |
Caterpillar Information System:
Procedure to Install an Updated Body Position Switch on Certain 773F and 775F Off-Highway Trucks{1408} Procedure to Install an Updated Body Position Switch on Certain 773F and 775F Off-Highway Trucks{1408}
Installation Procedure for Product Link PL421 Retrofit for Generator Sets{7606} Installation Procedure for Product Link PL421 Retrofit for Generator Sets{7606}
Reports of Corrosion and Pitting on the Front and Rear Suspension Cylinders and Hoist Cylinders on Certain Off-Highway Trucks{5102, 7200, 7201, 7213} Reports of Corrosion and Pitting on the Front and Rear Suspension Cylinders and Hoist Cylinders on Certain Off-Highway Trucks{5102, 7200, 7201, 7213}
3512C and 3516C Marine Auxiliary Engines Electrical Power Supply - Test
2012/12/18 Replacement Bodies For the 773F, 775F, and 777F Off-Highway Trucks Will Now Be Serviced With the 773G, 775G, and 777G Off-Highway Trucks Production Bodies {7258}
Drain Valves Leak on Certain Fuel Filters{1260, 1261} Drain Valves Leak on Certain Fuel Filters{1260, 1261}
3500 Generator Sets Fluid Recommendations
3500 Generator Sets Refill Capacities
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Rotating Rectifier - Inspect/Test
PM3516 Power Modules Generator Winding Insulation - Test
3500 Generator Sets Generator Winding - Test
C175-16 Marine Propulsion Engines Engine Design
3500 Generator Sets Engine Air Precleaner - Check/Clean
C7.1 Generator Set Alternator - Remove
C7.1 Generator Set Alternator - Install
3512C and 3516C Marine Auxiliary Engines Speed/Timing - Test
Deposits in C175 Engine Fuel Injectors{1251, 1254, 1290, 1713} Deposits in C175 Engine Fuel Injectors{1251, 1254, 1290, 1713}
G3304B and G3306B Engines Fan Drive Bearing - Lubricate
C1.5 and C2.2 Industrial Engines Overspeed
C7 Engines for Caterpillar Built Machines Camshaft
C1.5 and C2.2 Industrial Engines Monitoring System
3512C and 3516C Marine Auxiliary Engines Sensor Signal (Analog, Active) - Test
Crankshaft Timing Ring on Certain C4.4 Engines{1202} Crankshaft Timing Ring on Certain C4.4 Engines{1202}
3512C and 3516C Marine Auxiliary Engines Sensor Signal (Analog, Passive) - Test