C175-16 Marine Engine Caterpillar

Removal Procedure

Start By:

1. Remove the electronic control module.

2. Remove the temperature control valve.

3. Remove the fuel filter housing.

Show/hide table

NOTICE
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates.

1. Drain the oil from the engine oil filter housing into a suitable container for storage or for disposal.
   Show/hide table

   Illustration 1	g02408998

2. Attach Tooling (A) and a suitable lifting device onto engine oil filter housing (1). The weight of engine oil filter housing (1) is approximately 164 kg (362 lb). Remove bolts (2), elbows (3), and tube assemblies (5) and (6). Remove bolts (4).
   Show/hide table

   Illustration 2	g02408999

3. Disconnect tube assembly (9) and (10). Remove bolts (11) and engine oil filter housing (1). Remove bolts (7) and remove support assembly (8).

Installation Procedure

Show/hide table

Illustration 3	g02408999

1. Attach Tooling (A) and a suitable lifting device onto engine oil filter housing (1). The weight of engine oil filter housing (1) is approximately 164 kg (362 lb). Position support assembly (11) and install bolts (7). Position engine oil filter housing (1) onto support assembly (8). Install bolts (11). Connect tube assemblies (9) and (10).
   Show/hide table

   Illustration 4	g02408998

2. Install bolts (4) in engine oil filter housing (1). Position tube assembly (6) and elbow (3) and install bolts (2). Position tube assembly (5) and elbow (3) and install bolts (2).

3. Check the engine oil level. Refer to Operation and Maintenance Manual, "Engine Oil Level - Check".

End By:

1. Install the fuel filter housing.

2. Install the temperature control valve.

3. Install the electronic control module.