Auxiliary Drive (Front) - Remove and Install
Removal Procedure
- Refer to Operation and Maintenance Manual, "Belts - Inspect/Adjust/Replace" for the removal and installation of the belts.
- Remove nuts (1) and remove auxiliary drive (2) .
Show/hide table
Illustration 1 | g02678902 |
- Remove studs (3) , (4) , and (5) .
Show/hide table
Illustration 2 | g02678939 |
Installation Procedure
- Install auxiliary drive (2) in the reverse order of removal.
- Tighten studs (3) to a torque of 35 ± 5 N·m (26 ± 4 lb ft). Tighten nuts (1) to a torque of 47 ± 9 N·m (35 ± 7 lb ft).
Caterpillar Information System:
Retrofitting for Ultra Lean Burn (ULB) on a G3512 Engine{1000, 775E} Retrofitting for Ultra Lean Burn (ULB) on a G3512 Engine{1000, 775E}
C3.4B Engines For Caterpillar Built Machines Electronic Control Module
C13, C15, and C18 Tier 4 Final Engines Engine Oil Filter Base
C9.3 Tier 4 Final Engines Engine Oil Filter Base
C4.4 Marine Generator Set Emergency Stopping
TA19 M4WD Agricultural Transmission Transmission System
TA19 M4WD Agricultural Transmission General Information
Retrofitting a Cat 270 Air Compressor with a BA-921 CR Air Compressor on Certain C13 and C15 On-Highway Engines{1803} Retrofitting a Cat 270 Air Compressor with a BA-921 CR Air Compressor on Certain C13 and C15 On-Highway Engines{1803}
2011/08/04 Correction to Troubleshooting, SENR6493 , "3512 Engine Oil Well Service" {1265, 1901}
3516C Generator Set Engines Sensor Signal (Analog, Passive) - Test
C4.4 Marine Generator Set Generator Set Vibration - Test/Record
C4.4 Marine Generator Set Product Description
3516C Generator Set Engines Sensor Signal (PWM) - Test
C27 and C32 Industrial Engines Auxiliary Drive (Front) - Disassemble
C27 and C32 Industrial Engines Auxiliary Drive (Front) - Assemble
CG137-08 and CG137-12 Industrial Engines Sensor Signal (Analog, Active) - Test
Checking the High-Pressure Relief Valve for Leakage on C6.6 and C4.4 Engines{1288} Checking the High-Pressure Relief Valve for Leakage on C6.6 and C4.4 Engines{1288}
TA19 M4WD Agricultural Transmission Location of Electronic Components for Transmission System
2013/08/21 A New Oversized Cylinder Bore Liner Seal Insert Is Available for 3500 Engine Cylinder Block Salvage {1201, 7555}
3516C Generator Set Engines Sensor Supply - Test
C27 Generator Set Electronic Modular Control Panel 4 (EMCP 4) - EMCP 4.3/4.4
C9.3 Engines for Caterpillar Built Machines Water Lines
C13, C15, and C18 Tier 4 Final Engines Water Pump
TA19 M4WD Agricultural Transmission Location of Hydraulic Components for Transmission System