C6.6 Marine Generator Set Caterpillar


E360 Low Engine Oil Pressure

Usage:

C6.6 C6T
Conditions Which Generate This Code:

The Electronic Control Module (ECM) detects a fault with the engine's oil pressure. The ECM detects the following faults:

  • The engine has been running for more than ten seconds.

  • The oil pressure is below the trip point for the event code. Refer to Table 1 for a list of trip points for low oil pressure.

  • Diagnostic code 100-3 Engine Oil Pressure open/short to +batt is not active.

  • Diagnostic code 100-4 Engine Oil Pressure short to ground is not active.

Note: This event code represents an event. This does not represent an electronic system fault.

Table 1
Trip Points for Low Oil Pressure    
    E360-1     E360-3    
    RPM     kPa Gauge     RPM     kPa Gauge    
Trip point     0     0     0     0    
1500
250 kPa (36 psi)    
1500    
100 kPa (14 psi)    
1800
250 kPa (36 psi)    
1800    
100 kPa (14 psi)    
Delay to activation     8 seconds     4 seconds    

System Response:

The event code will be logged.

The warning lamp will be illuminated and the warning horn may sound. If equipped, the diagnostic lamp will flash the event code.

E360-1

None

E360-3

The ECM will derate the power at 17 percent per second for two seconds.

The shutdown lamp will be illuminated. If the "Enable Shutdown" parameter is enabled, the engine will shut down.

Test Step 1.

Refer to Troubleshooting, "Low Engine Oil Pressure".

Results:

  • OK - STOP

Caterpillar Information System:

C6.6 Marine Generator Set E264 Emergency Stop Activated
3516C Locomotive Engine and Generator Set Fuel System Primary Filter/Water Separator - Clean/Replace
Installation of the Alarm Communication Relay Card{4480} Installation of the Alarm Communication Relay Card{4480}
2010/01/18 An Improved Engine Oil Cooler Core Is Available for G3520C Engines that use Bio-gas {1378}
C27 Generator Set Engines Camshaft
C6.6 Marine Generator Set E085 Engine Shutdown Overridden
C27 and C32 Tier 4 Engines Electronic Unit Injector Mechanism
3524B and C175 Engines for Off-Highway Truck/Tractors Accessory Drive - Air and refrigerant compressor
C6.6 Marine Generator Set CID 1779 FMI 08
C6.6 Marine Generator Set CID 1690 FMI 08
C13, C15, and C18 Tier 4 Interim Engines Cooling Fan Control - Test
C27 and C32 Engines for Caterpillar Built Machines Fuel Filter Base
797 Off-Highway Truck Electric Drive Pump (Powered Stairway) Oil Level - Check - If Equipped
Recommended Storage Procedures For Hydraulic Excavators {0355, 1000, 1250, 7000} Recommended Storage Procedures For Hydraulic Excavators {0355, 1000, 1250, 7000}
Updating the Wiring Harness of the Engine Brake on Some C15 Engines{1290, 1408} Updating the Wiring Harness of the Engine Brake on Some C15 Engines{1290, 1408}
C27 Generator Set Engines Coolant Temperature Sensor
Procedure for Reworking the Diodes In the Alternator Charging Circuit{1405, 7451} Procedure for Reworking the Diodes In the Alternator Charging Circuit{1405, 7451}
C13, C15, and C18 Tier 4 Interim Engines Data Link - Test
C6.6 Marine Generator Set E362 Engine Overspeed
C6.6 Marine Generator Set E396 High Fuel Rail Pressure
C6.6 Marine Generator Set E398 Low Fuel Rail Pressure
C6.6 Marine Generator Set E539 High Intake Manifold Air Temperature
C13, C15, and C18 Tier 4 Interim Engines Aftertreatment Cooling Fan - Test
The Long Term Storage and Recovery of Certain Commercial Engines{0355, 1000} The Long Term Storage and Recovery of Certain Commercial Engines{0355, 1000}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.