E085 Engine Shutdown Overridden
Conditions Which Generate This Code:
The emergency shutdown override switch has been set to Override.
Note: This event code indicates a switch position. The code does not indicate a fault in the electronic system.
System Response:
The event code will be logged.
The warning lamp will be illuminated. If equipped, the diagnostic lamp will flash the event code.
The event may be viewed by using a display module or by using the electronic service tool.
E085-1
None
Test Step 1.
This event indicates that the emergency shutdown override switch has been activated. This event does not represent a fault in the Electronic Control Module (ECM).
The engine will not shut down automatically in an emergency situation.
No troubleshooting is required.
Results:
- OK - STOP
Caterpillar Information System:
C27 and C32 Tier 4 Engines Electronic Unit Injector Mechanism
3524B and C175 Engines for Off-Highway Truck/Tractors Accessory Drive - Air and refrigerant compressor
C6.6 Marine Generator Set CID 1779 FMI 08
C6.6 Marine Generator Set CID 1690 FMI 08
C13, C15, and C18 Tier 4 Interim Engines Cooling Fan Control - Test
C27 and C32 Engines for Caterpillar Built Machines Fuel Filter Base
C13, C15, and C18 Tier 4 Interim Engines Air Shutoff - Test
793F Off-Highway Truck Machine Systems Window Wiper Motor - Remove and Install
C175-16 Locomotive Engine Exhaust Manifold
3500 Engines Water Connection Group
3508C, 3512C and 3516C Locomotive Engines Turbocharger
C175-16 Engine for Off-Highway Trucks Engine Trunnion
C27 Generator Set Engines Camshaft
2010/01/18 An Improved Engine Oil Cooler Core Is Available for G3520C Engines that use Bio-gas {1378}
Installation of the Alarm Communication Relay Card{4480} Installation of the Alarm Communication Relay Card{4480}
3516C Locomotive Engine and Generator Set Fuel System Primary Filter/Water Separator - Clean/Replace
C6.6 Marine Generator Set E264 Emergency Stop Activated
C6.6 Marine Generator Set E360 Low Engine Oil Pressure
797 Off-Highway Truck Electric Drive Pump (Powered Stairway) Oil Level - Check - If Equipped
Recommended Storage Procedures For Hydraulic Excavators {0355, 1000, 1250, 7000} Recommended Storage Procedures For Hydraulic Excavators {0355, 1000, 1250, 7000}
Updating the Wiring Harness of the Engine Brake on Some C15 Engines{1290, 1408} Updating the Wiring Harness of the Engine Brake on Some C15 Engines{1290, 1408}
C27 Generator Set Engines Coolant Temperature Sensor
Procedure for Reworking the Diodes In the Alternator Charging Circuit{1405, 7451} Procedure for Reworking the Diodes In the Alternator Charging Circuit{1405, 7451}
C13, C15, and C18 Tier 4 Interim Engines Data Link - Test