E264 Emergency Stop Activated
Conditions Which Generate This Code:
The emergency stop button has been depressed.
Note: This event code indicates a switch position. The code does not indicate a fault in the electronic system.
System Response:
The warning lamp will be illuminated and the warning horn may sound. If equipped, the diagnostic lamp will flash the event code.
The event may be viewed by using a display module or by using the electronic service tool.
E264-1
None
Test Step 1.
This event indicates that the emergency stop button has been depressed. This event does not represent a fault in the Electronic Control Module (ECM).
The engine will be shut down.
No troubleshooting is required.
Results:
- OK - STOP
Caterpillar Information System:
3516C Locomotive Engine and Generator Set Fuel System Primary Filter/Water Separator - Clean/Replace
Installation of the Alarm Communication Relay Card{4480} Installation of the Alarm Communication Relay Card{4480}
2010/01/18 An Improved Engine Oil Cooler Core Is Available for G3520C Engines that use Bio-gas {1378}
C27 Generator Set Engines Camshaft
C6.6 Marine Generator Set E085 Engine Shutdown Overridden
C27 and C32 Tier 4 Engines Electronic Unit Injector Mechanism
3524B and C175 Engines for Off-Highway Truck/Tractors Accessory Drive - Air and refrigerant compressor
C6.6 Marine Generator Set CID 1779 FMI 08
C6.6 Marine Generator Set CID 1690 FMI 08
C13, C15, and C18 Tier 4 Interim Engines Cooling Fan Control - Test
C27 and C32 Engines for Caterpillar Built Machines Fuel Filter Base
C13, C15, and C18 Tier 4 Interim Engines Air Shutoff - Test
C6.6 Marine Generator Set E360 Low Engine Oil Pressure
797 Off-Highway Truck Electric Drive Pump (Powered Stairway) Oil Level - Check - If Equipped
Recommended Storage Procedures For Hydraulic Excavators {0355, 1000, 1250, 7000} Recommended Storage Procedures For Hydraulic Excavators {0355, 1000, 1250, 7000}
Updating the Wiring Harness of the Engine Brake on Some C15 Engines{1290, 1408} Updating the Wiring Harness of the Engine Brake on Some C15 Engines{1290, 1408}
C27 Generator Set Engines Coolant Temperature Sensor
Procedure for Reworking the Diodes In the Alternator Charging Circuit{1405, 7451} Procedure for Reworking the Diodes In the Alternator Charging Circuit{1405, 7451}
C13, C15, and C18 Tier 4 Interim Engines Data Link - Test
C6.6 Marine Generator Set E362 Engine Overspeed
C6.6 Marine Generator Set E396 High Fuel Rail Pressure
C6.6 Marine Generator Set E398 Low Fuel Rail Pressure
C6.6 Marine Generator Set E539 High Intake Manifold Air Temperature
C13, C15, and C18 Tier 4 Interim Engines Aftertreatment Cooling Fan - Test