Diesel Particulate Filter Temperature and Pressure Sensor
Show/hide table
 | |
| Illustration 1 | g01884714 |
(1) Final installation torque for the fitting ... 11 ± 2 N·m (8 ± 1.5 lb ft)
(2) Final installation torque for the temperature and pressure sensors ... 45 ± 5 N·m (33 ± 4 lb ft)
Operating voltage ... 4.75 to 5.25 VDC
Output type ... Analog
Operating temperature ... −40 to 900 °C (−40 to 1652 °F)
Operating Pressure ... 0 to 35 kPa (0 to 5.1 psi)
Caterpillar Information System:
C13 Engine Housing (Front) - Remove
C13 Engine Gear Group (Front) - Install
C15 and C18 Industrial Engines Combustion Head - Remove and Install
C13 Engine Gear Group (Front) - Remove
C13 Engine Front Cover - Install
C13 Engine Front Cover - Remove
C13 Engine Crankshaft Front Seal - Install
C13 Engine Crankshaft Front Seal - Remove
C13 Engine Rear Power Take-Off (RPTO) - Install
C7 On-highway Engine Diesel Particulate Filter
C13 Engine Rear Power Take-Off (RPTO) - Remove
C13 Engine Flywheel Housing - Remove and Install
C13 Engine Housing (Front) - Install
789D, 793F, and 797F Off-Highway Truck Monitoring System Charging System
2009/04/20 An Improved Exhaust Bellows Assembly Is Used on 3500HD Locomotive Engines {1052, 1053}
C13 Engine Accessory Drive - Remove
C13 Engine Accessory Drive - Install
C13 Engine Valve Mechanism Cover - Remove and Install
C13 Engine Valve Mechanism Cover Base - Remove and Install
C13 Engine Valve Actuator (Variable) - Remove
C13 Engine Valve Actuator (Variable) - Install
C13 Engine Rocker Shaft and Pushrod - Remove
C13 Engine Rocker Shaft - Disassemble
C13 Engine Rocker Shaft - Assemble