Housing (Front) - Install
- Position front housing (3).
- Install bolts (2).
- Tighten the oil pan bolts.
- Install front engine mount (4).
- Connect sensor (1).
Show/hide table
Illustration 1 | g01011130 |
End By:
- Install the engine crankshaft sensor. Refer to Disassembly and Assembly, "Engine Sensors - Remove and Install".
- Install the front gear group. Refer to Disassembly and Assembly, "Gear Group (Front) - Install".
- Install the camshaft. Refer to Disassembly and Assembly, "Camshaft - Install".
- Install the water pump. Refer to Disassembly and Assembly, "Water Pump - Install".
- Install the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Install".
- Install the air compressor. Refer to Disassembly and Assembly, "Air Compressor - Remove and Install".
Caterpillar Information System:
C7 On-highway Engine Diesel Particulate Filter Temperature and Pressure Sensor
C13 Engine Housing (Front) - Remove
C13 Engine Gear Group (Front) - Install
C15 and C18 Industrial Engines Combustion Head - Remove and Install
C13 Engine Gear Group (Front) - Remove
C13 Engine Front Cover - Install
C13 Engine Front Cover - Remove
C13 Engine Crankshaft Front Seal - Install
C13 Engine Crankshaft Front Seal - Remove
C13 Engine Rear Power Take-Off (RPTO) - Install
C7 On-highway Engine Diesel Particulate Filter
C13 Engine Rear Power Take-Off (RPTO) - Remove
789D, 793F, and 797F Off-Highway Truck Monitoring System Charging System
2009/04/20 An Improved Exhaust Bellows Assembly Is Used on 3500HD Locomotive Engines {1052, 1053}
C13 Engine Accessory Drive - Remove
C13 Engine Accessory Drive - Install
C13 Engine Valve Mechanism Cover - Remove and Install
C13 Engine Valve Mechanism Cover Base - Remove and Install
C13 Engine Valve Actuator (Variable) - Remove
C13 Engine Valve Actuator (Variable) - Install
C13 Engine Rocker Shaft and Pushrod - Remove
C13 Engine Rocker Shaft - Disassemble
C13 Engine Rocker Shaft - Assemble
C13 Engine Rocker Shaft and Pushrod - Install