C13 Engine for Caterpillar Built Machines Caterpillar

Assembly Procedure

Show/hide table

Illustration 1	g02173629

Note: Lubricate all of the O-ring seals with the lubricant that is being sealed.

1. Install O-ring seals (9).
   Show/hide table

   Illustration 2	g01845473

2. Install spool (5). Tighten spool (5) to a torque of 50 ± 5 N·m (37 ± 4 lb ft).

3. Install solenoid (6), washer (7), and nut (8). Tighten nut (8) to a torque of 20 ± 2.5 N·m (177 ± 22 lb in) .
   Show/hide table

   Illustration 3	g01871983

4. Fill Cavity (B) with Tooling (B). Cavity (B) is found on the valve housing.
   Show/hide table

   Illustration 4	g02173623

5. Install actuator assembly (3) on valve housing (4).

6. Apply Tooling (A) to the threads on temperature sensor (1). Tighten temperature sensor (1) to a torque of 45 ± 5 N·m (33 ± 4 lb ft).

End By:

1. Install the exhaust control valve.