Pump Drive - Remove
拆卸步骤
Show/hide table
所需工具     | |||
---|---|---|---|
工具     | 零件号     | 零件描述     | 数量     |
A     | 138-7575     | 连杆支架     | 3     |
B     | 1P-2420     | 变速箱修复台     | 1     |
开始:
- 从变速箱上拆下变矩器。 请参阅拆解和装配, "变速箱和变矩器 - 分离"。
- 拆下变矩器。 请参阅拆解和组装, "变矩器 - 拆卸"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
注意 |
---|
在检验、保养、测试、调整及维修发动机时,请小心确保盛接流出的液体。 在打开或拆解任何储有液体的部件之前,要准备好合适的容器收集液体。 有关适合收集和盛接卡特彼勒产品上的液体的工具和供应品,请参阅专门出版物, NENG2500, "卡特彼勒代理商工具目录"。 按照本地法规和条例处置所有液体。 |
- 利用工具 (A) 和适当的起吊设备将变矩器壳体 (1) 定位到工具 (B) 上。 变矩器 (1) 的重量约为 134 kg (295 lb)。
Show/hide table
图 1 | g01804644 |
- 拆下螺栓 (2) 和防护罩组件 (3) 。
Show/hide table
图 2 | g01804674 |
- 卸下螺栓 (4) 。 使用工具 (A) 和适当的起吊设备拆下泵驱动装置 (5) 。 泵驱动装置 (5) 的重量约为 31 kg (70 lb)。
Show/hide table
图 3 | g01804753 |
- 拆下 O 形密封圈 (6) 。
Show/hide table
图 4 | g01805517 |
Caterpillar Information System:
345D, 349D and 349D2 Excavators and 345D MHPU, 349D MHPU and 349D2 MHPU Mobile Hydraulic Power Units Machine Electronic Control System MID 039 - CID 0588 - FMI 09
345D, 349D and 349D2 Excavators and 345D MHPU, 349D MHPU and 349D2 MHPU Mobile Hydraulic Power Units Machine Electronic Control System MID 039 - CID 0588 - FMI 12
2009/02/16 Disposable Paper Air Filters Require Protection {1051, 1054}
795F AC and 795F AC XQ Off-Highway Trucks Air Filter Element (Inverter Cabinet) - Clean/Replace - Metal Sand Filters
2009/02/02 Shims Are Now Used in the Carburetors of G3516 Engines {1266}
3512B Generator Set Engine Diagnostic Trouble Codes
CX31-P600 Petroleum Transmission Well Servicing Relief Valve (Torque Converter Inlet) - Remove and Install
2009/02/02 A New Seal Is Used for the Ignition Transformers inG3600 Engines {1550, 7555}
2009/02/01 A New Connecting Rod Bearing is Available {1218, 1219, 1225}
2009/02/16 New Rocker Arms Are Available {1123}
C9 Marine Engines and C9 Marine Generator Sets Flexible Coupling
C9 Marine Engines and C9 Marine Generator Sets Drive Shaft
CX35-P800 Petroleum Transmission and Petroleum Power Train Packages Pump Drive - Install
345D, 349D and 349D2 Excavators and 345D MHPU, 349D MHPU and 349D2 MHPU Mobile Hydraulic Power Units Machine Electronic Control System MID 039 - CID 0600 - FMI 04
2009/02/02 A New Rocker Arm Assembly is Available {1123}
2011/09/12 A New Rocker Arm Assembly Is Available {1123}
2009/03/02 Pressure Requirements for the Fuel Supply of the C175 Engine {1250}
2009/02/09 Improvement to the Oil Pressure Switch {7400, 7421}
2009/03/30 Introduction of a New Fuel Filter Base {1260, 1261}
CX35-P800 Petroleum Transmission and Petroleum Power Train Packages Pump Drive - Disassemble
CX35-P800 Petroleum Transmission and Petroleum Power Train Packages Pump Drive - Assemble
2009/04/06 New Software Is Available for C18 Marine Engines {1901, 1920}
C175-16 and C175-20 Generator Set Engines Fuel Pressure Is Low - Fuel Transfer System
C175-16 and C175-20 Generator Set Engines Fuel Pressure Is High - Fuel Transfer System