Water Pump - Remove
Removal Procedure
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Drain the coolant from the cooling system into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
- Disconnect hose assembly (1) and tube assembly (2) .
Show/hide table
 | |
| Illustration 1 | g01681905 |
- Disconnect hose assembly (3) .
- Remove bolts (6) and remove oil cooler bonnet (7) .
Show/hide table
 | |
| Illustration 2 | g01683015 |
- Remove bolts (4) and remove water pump cover (5) .
- Remove bolts (8) and remove water pump (9) .
Show/hide table
 | |
| Illustration 3 | g01683053 |
Caterpillar Information System:
G3508B, G3512B, G3512B, G3516B and G3520B Petroleum Engines Aftercooler - Remove and Install
R250 Automatic Voltage Regulator General Information
Parts for Updating Early 3406E Aftercooler Cores{1063} Parts for Updating Early 3406E Aftercooler Cores{1063}
R250 Automatic Voltage Regulator High Voltage
Upgrade to Air/Fuel Ratio Control, Nitrogen Oxide Sensor, and a Single Turbocharger for Enhanced Performance of G3508 Engines{1000, 1052, 1270, 191N} Upgrade to Air/Fuel Ratio Control, Nitrogen Oxide Sensor, and a Single Turbocharger for Enhanced Performance of G3508 Engines{1000, 1052, 1270, 191N}
G3508B, G3512B, G3512B, G3516B and G3520B Petroleum Engines Exhaust Elbow - Remove and Install
320D and 323D Excavators Machine System Specifications Grease Lines
3500B Engines for Caterpillar Built Power Modules Turbocharger
3500B Generator Set Engines Turbocharger
C18 Fire Pump Industrial Engine Turbocharger - Install - Dual Turbocharger
C18 Fire Pump Industrial Engine Turbocharger - Remove - Dual Turbocharger
C18 Fire Pump Industrial Engine Fuel Filter Base - Install
Prevention of Leaks in the C18 Marine Heat Exchanger Frame {1379, 1395} Prevention of Leaks in the C18 Marine Heat Exchanger Frame {1379, 1395}
No Starboard Throttle Signal{3065, 4490} No Starboard Throttle Signal{3065, 4490}
3500 Generator Sets with Dynamic Gas Blending Fan Drive Bearing - Lubricate
R250 Automatic Voltage Regulator No Voltage
C175-16 Petroleum Generator Set Engines Model View Illustrations
R250 Automatic Voltage Regulator Low Voltage
R250 Automatic Voltage Regulator Load Acceptance Module Operation
C18 Fire Pump Industrial Engine Water Pump - Install
R250 Automatic Voltage Regulator Wiring Diagram
C175-16 Petroleum Generator Set Engines Engine Oil and Filter - Change
R250 Automatic Voltage Regulator Knee Frequency - Adjust - For Constant Volts Per Hertz Operation
C18 Fire Pump Industrial Engine Water Temperature Regulator Housing - Remove and Install