A New Ram Support For Use With The Field Service Hose Press{0623}
Usage:
A 5P8735 Ram Support (see Illustration 1) is now available for use with the 5P170 and 5P4180 Field Service Hose Press. The new ram support is used to hold either the 5P174 or 5P4166 Ram in position in the hose press (see Illustration 2). The ram support gives the operator a free hand for the alignment of the hose coupling. Use of the ram support decreases the time needed to do the job.
Illustration 1.
Illustration 2.
Caterpillar Information System:
1978/08/28 Tips For Service Information Retrieval System (SIRS) Users{0374}
1978/08/21 Improved Piston Pins Are Made Of Different Material For Better Hardness Characteristics When Heat Treated{1214}
1978/08/21 Improved Guide Pin For Fuel Injection Pump Lifters{1251}
1978/08/21 Sleeve-Type Ring Compressors Can Be Used For Installation Of Pistons From The Bottom Of The Engine{0622}
1978/08/21 Overlap Joint On Crankshaft Front Seal Ring Prevents Leakage{1160,1202}
1978/08/21 Take Advantage Of The Assembly Procedures And Specifications Charts{0374}
1978/08/07 Remove Fuel Injection Nozzles Before The Bottom Surface Of A Cylinder Head Is Cleaned{1254,1101}
1978/08/07 New Glow Plug Wiring Harness Prevents Short Circuit{1403}
1978/08/07 Four New Contact Points Added To 5P6524 Engine Timing Indicator Group{0653}
1978/07/10 Drill Hole In Handle Of Early 5P3520 Spanner Wrenches For Use With 5P8675 Extension Handle{0620}
1978/07/10 New Flange-Type Seal Used At Rear Of Crankshaft{1161}
1978/07/03 Disconnected Air Cleaner Hose Can Cause Engine Damage{1058,1051}
1978/08/28 Change In Procedure To Check Main Bearing Clearance{1203}
1978/08/28 New Design Seals Decrease Shaft Wear In Fuel Transfer Pump{1256}
1978/08/28 New 5P8744 Adapter Assembly And Special Instruction Procedures For 5P4150 Nozzle Tester Group{0650}
1978/08/28 New Oil Supply Line And Gasket For Turbocharger{1307,1052}
1978/08/28 Different O-Ring Seals Now Used In Fuel Injection Pump Group{1251}
1978/09/04 New Camshaft Rear Bearing For The Sleeve Metering Fuel System{1253}
1978/09/04 New Vent Tube For Water Cooled Turbocharger{1380,1052}
1978/09/04 New Torque Specification Used On Bolts That Hold The Cylinder Head{1101}
1978/09/04 Correct Procedure To Adjust Front Power Takeoff Clutches{3055}
1978/09/04 New Gasket Used In Exhaust Manifold Group{1059}
1978/09/04 New Nozzle Assembly Used In Fuel Injection Valves{1254}
1978/09/04 New Water Pump Gives More Pressure{1361}