Pressure Sensor (Front Suspension Cylinder)
Show/hide table
| |
| Illustration 1 | g01946664 |
(1) Final installation torque for the pressure sensor group ...
Supply voltage ... 8 to 32 VDC
Frequency range ... 200.00 to 1602.56 Hz
Operating temperature ...
Note: The pressure sensor group may be installed 90 degrees in either directions from the vertical position. The port of the pressure sensor group should be pointed in the downward direction.
Caterpillar Information System:
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Crankshaft Pulley - Remove and Install
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Remove and Install
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Flywheel - Install
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Flywheel - Remove
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Oil Pump - Install
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Oil Line - Remove and Install
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Inlet and Exhaust Valves - Remove and Install
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Springs - Remove and Install
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Exhaust Manifold - Remove and Install
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel Injector - Remove and Install
C4.4 Industrial Engine Refill Capacities and Recommendations
3406E and C15 Marine Engines Auxiliary Water Pump
2008/05/12 Improved Engine Software is Available {1901, 1920}
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Basic Engine
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines General Information
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Housing (Front) - Install
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Crankcase Breather - Remove and Install - Naturally Aspirated Engines
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Electrical System
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Rocker Shaft and Pushrod - Install
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Camshaft - Remove
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel Injection Timing - Check
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Camshaft - Install