D6K and D6K2 Track-Type Tractor Monitoring System Caterpillar

Illustration 1	g06007506
Service Menu

The following list contains some of the functions of the display module:

• The diagnostic codes of the ECM systems are displayed.

• The number of occurrences and the clock hour of the first and last occurrence are displayed for each of the events, active codes, and logged codes.

• The definition for each logged diagnostic code and each event is displayed.

Illustration 2	g03862071
"Configurations" will not visible in the Service Menu when Service Mode is disabled. Some "Calibration" features (Factory Grade Control) will be hidden when Service Mode is not enabled.

Configurations

Illustration 3	g06005698
Configuration menu

The Configurations menu will appear only if the operator enters the Service mode password through the Service mode menu. The Service Mode password is 32768. Service Configurations allows the access to the following advanced settings:

• Park Brake Lockout: Not Lockout/Lockout.

• Blade Installation: Installed/Not Installed.

• Max Track Speed: Forward/Reverse.

• Engine Idle Shutdown: Set Delay Time/Enable/Disable.

• AccuGrade: Automatic Detection/Enable/Disable.

• Rear Implement: Not Installed/Ripper/Winch.

• Slope Assist: Installed/Not Installed.

Max Track Speed

Illustration 4	g06008252

Engine Idle Shutdown

Illustration 5	g06008265

AccuGrade

Illustration 6	g06018955

Rear Implement

Illustration 7	g06018959

Diagnostics

Illustration 8	g06008415
(1) Fault Code (2) Fault Description

Illustration 9	g03870476
Diagnostics screen

The "Diagnostics" menu option will show a complete list of all active events and the logged event codes and diagnostic codes.

Codes and events that are contained in the system Diagnostics may be viewed at any time. The logged codes cannot be cleared until the Service Mode is enabled.

Press the "OK" key while you are in the "Diagnostics" menu option to display the Diagnostic message screen.

Each line that is listed contains the following information about that event or that code.

Fault Code (1) - Component Identifier or Failure Mode Identifier (CID-EID).

Fault Description (2) - Diagnostic code identifier.

Communicating Active Faults or Events

When the diagnostic message is acknowledged, a predetermined length of time passes before the message screen will appear on the monitoring system display again. This interval is dependent upon the severity of the warning level. Consult the appropriate warning category for the proper instruction.

ECM Summary

Illustration 10	g06008435

The ECM Summary menu will display information for each ECM installed on the machine.

This menu organizes the systems into the following five categories:

• Engine

• Auxiliary

• Implement

• Product Link

• Display

The following information will be displayed for each ECM:

• ECM Serial Number

• HW Part Number

• SW Part Number

• SW Release Date

• SW Description

Parameters

Illustration 11	g06008471

The Parameters menu will display the value of several sensors. This menu may be useful for troubleshooting purpose. Scroll down to navigate through the different systems monitored.

This menu organizes the systems into the following six categories:

• Engine

• Hystat

• Steering

• Brake

• Implement

• Rear implement

Service Mode

To Enable Service Mode

Illustration 12	g06124319

On the Service Mode page, highlight "Enable" and press the "OK" button. This will move the check mark and enable Service Mode.

When Service Mode is enabled, previously hidden Service Mode items will be viewable in the Service menu. The scroll bar will appear due to the two new items (Configurations and Calibration) that appear in the menu.