Control Valve (Transmission Clutch Latching) - Install
安装步骤
注: 检查 O 形密封圈是否磨损或损坏。 如有必要，更换这些部件。
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 安装 O 形密封圈和控制阀 (3) 。 安装螺栓 (2) 。 拧紧螺栓 (2) 至扭矩 55 ± 10 N·m (41 ± 7 lb ft)。 连接线束组件 (1) 。
Show/hide table
 | |
| 图 1 | g01389583 |
Caterpillar Information System:
G3500 A3 Engines Exhaust Bypass Valve - Adjust
2007/08/27 The Turbocharger Water Lines are Improved {1380}
CX28 On-Highway Transmission Control Valve (Transmission Clutch Latching) - Assemble
C7 Marine Engine Coolant Temperature Sensor
C7 Marine Engine Fuel Temperature Sensor - If Equipped
CX28 On-Highway Transmission Control Valve (Transmission Clutch Latching) - Disassemble
C4.4 (Mech) Industrial Engine Water Temperature Regulator
G3500 A3 Engines Nitrogen Oxide Sensor
C15 On-Highway Engine Fuel Pressure Sensor - Remove and Install
C7 Marine Engine Coolant Level Sensor - If Equipped
C7 Petroleum Engine Fuel System - Prime
C7 Petroleum Engine Monitoring System - If Equipped
G3500C and G3500E Generator Set Engines Electronic Control System Operation
G3500C and G3500E Generator Set Engines Electronic Control Module (ECM)
G3500C and G3500E Generator Set Engines Engine Sensors
G3500C and G3500E Generator Set Engines Ignition System
G3500C and G3500E Generator Set Engines Aftercooler
G3512 Generator Set Engines Crankshaft
G3512 Generator Set Engines Camshaft
G3500C and G3500E Generator Set Engines Crankshaft Position for Valve Lash Setting
Bench Test Procedure for a 14L, 120M, 120M Series 2, 12M, 12M Series 2, 12M Series 3, 140M, 140M Series 2, 140M Series 3, 160M, 160M Series 2, and 160M Series 3 Motor Grader Transmission {3030, 3073} Bench Test Procedure for a 14L, 120M, 120M Series 2, 12M, 12M Series 2, 12M Series 3, 140M, 140M Series 2, 140M Series 3, 160M, 160M Series 2, and 160M Series 3 Motor Grader Transmission {3030, 3073}
G3520C and G3520E Engines Temperature Sensor
3408C and 3412C Marine Engines Fuel Injection Lines
3408B and 3408C Industrial and Marine Engines Camshaft Bearings