Component Location
Locations of the Engine Sensors
Show/hide table
| |
| Illustration 1 | g01385506 |
|
Locations of the engine sensors (left side engine view) (1) Engine coolant temperature sensor (2) Left exhaust temperature sensor (3) Connector for the air shutoff solenoid (4) Left turbocharger compressor inlet pressure sensor (5) Location of the secondary engine speed/timing sensor (6) Location of the primary engine speed/timing sensor (7) Crankcase pressure sensor (8) Enclosure for the starter magnetic switch | |
Show/hide table
| |
| Illustration 2 | g01385507 |
|
Locations of the engine sensors (right side engine view) (9) Right turbocharger compressor inlet pressure sensor (10) Right exhaust temperature sensor (11) Unfiltered fuel pressure sensor (12) Filtered fuel pressure sensor (13) Timing calibration sensor (14) Unfiltered oil pressure sensor (15) Filtered oil pressure sensor | |
Show/hide table
| |
| Illustration 3 | g01385509 |
|
Locations of the engine sensors (front engine view) (16) Turbocharger compressor outlet pressure sensor (17) Atmospheric pressure sensor (18) ECM (19) ECM connector J1 (20) ECM connector J2 | |
Show/hide table
| |
| Illustration 4 | g01385502 |
|
Block Diagram | |
Caterpillar Information System:
C7 and C9 Petroleum Engines Coolant Temperature Is High
C15 and C18 Generator Set Engines Exhaust Manifold - Remove and Install
3516C Locomotive Engine Emissions General Information
3512C Engine System Overview
3516C Locomotive Engine Emissions Emissions Warranty Information
C15 Petroleum Engines Reference Material
C7 and C9 Petroleum Engines Configuration Parameters
2007/09/24 New Software is Available for the Electronic Control Module (ECM) {1901, 1902, 7620}
2011/06/24 Recommended Rocker Arm for Applications with High Compression {1102, 1123}
2007/11/26 Recommended Rocker Arm for Applications with High Compression {1102, 1123}
C15 and C18 Industrial Engines Shutdown Timer (Idle) - Test
C13 and C15 On-highway Engines Oil Contains Fuel
3512C Industrial Engine Water Temperature Regulators - Remove
WAVS Installation Guide for Generic Applications{7347, 7348} WAVS Installation Guide for Generic Applications{7347, 7348}
C4.4 (MECH) Industrial Engine and Generator Sets Alternator Belt - Remove and Install - Engines With an Automatic Belt Tensioner
3500C Marine Propulsion Engines Maintenance Interval Schedule
3512C Industrial Engine Water Temperature Regulators - Install
3512C Engine Electrical Connectors
3500B Engines for Caterpillar Built Power Modules with the ADEM 3 Electronic Control Module Engine Overspeeds
C7 and C9 Petroleum Engines Cat Data Link - Test
3512C Industrial Engine Water Pump - Remove
C15 and C18 Generator Set Engines Water Pump - Disassemble
C15 and C18 Generator Set Engines Water Pump - Assemble
C32 Marine Auxiliary Engines Indicator Lamp - Test