Piston Motor (Steering) - Remove and Install
Start By:
- Remove the seat.
- Drain the hydraulic oil. Refer to Operation and Maintenance Manual, " Hydraulic System Oil – Change " for the correct draining and filling procedures.
- Remove the floor mat and the floor plate.
Show/hide table
Illustration 1 g03820761 - Disconnect hose assemblies (1).
Show/hide table
Illustration 2 g03820765 - Disconnect hose assembly (2), harness assembly (3), hose assembly (4), and hose assembly (5).
Show/hide table
Illustration 3 g03820767 - Remove bolts (6). Use two people in order to remove piston motor (7). The weight of piston motor (7) is approximately
45 kg (99 lb) . - Remove O-ring seal (8).
- Install piston motor (7) in the reverse order of removal.
Caterpillar Information System:
2015/06/10 A New Special Instruction , "Procedure for Replacing the Actuator on Certain H Series Wheel Tractor-Scrapers Equipped with Powered Access Ladders" is Now Available {7254}
D3K2, D4K2 and D5K2 Track-Type Tractors Machine Systems Bulldozer C-Frame (VPAT) - Remove and Install
D6R2 Track-Type Tractor Machine Systems Refrigerant Accumulator - Remove and Install
953K and 963K Track-Type Loaders Condenser (Refrigerant) - Clean
2015/04/03 A Heavy Duty Push Arm Step is now Available for Certain D6T and D7E Track-Type Tractors {6061, 6063, 7256}
D6R2 Track-Type Tractor Machine Systems Blower Motor (Air Conditioner, Heater) - Remove and Install
C13, C15, and C18 Tier 4 Final Engines Inlet Manifold Temperature Sensor
D6N Track-Type Tractor Electrohydraulic System Relay - Test
G3600 A4 Engines Pressure Sensor
D8T Track-Type Tractor Location of Components (Hydraulic System)
D8T Track-Type Tractor Piston Motor (Fan Drive)
D6R2 Track-Type Tractor Machine Systems Refrigerant Condenser - Remove and Install
924K, 926M, 930K, 930M, 938K and 938M Wheel Loaders Information Display Display Menu
D8T Track-Type Tractor Location of Components (Power Train System)
953K and 963K Track-Type Loaders Fuel System Filter (In-Line) - Replace
953K and 963K Track-Type Loaders Cab Filter (Recirculation) - Clean/Inspect/Replace
Procedure to Install VIMS Application Module for Payload on all Underground Articulated Trucks {7610, 7620} Procedure to Install VIMS Application Module for Payload on all Underground Articulated Trucks {7610, 7620}
336, 336 GC and 340 Excavator Systems Stick - 7.1 m (23.32 ft)
336F and 340F Excavators Machine System Specifications Auxiliary Hydraulic Lines
336, 336 GC and 340 Excavator Systems Stick Lines
C2.2 Engines For Caterpillar Built Machines General Information
336, 336 GC and 340 Excavator Systems Boom - 10.6 m (34.99 ft)
C2.2 Engines For Caterpillar Built Machines Welding Precaution
994K Wheel Loader Machine Systems Electronic Control Module (ECM) - Flash Program