Check the Gear Pump (Hoist, Steering, Brake, and Pilot) on AD30 Underground Articulated Trucks{4268, 4306, 5073, 5083, 5085} Caterpillar


Check the Gear Pump (Hoist, Steering, Brake, and Pilot) on AD30 Underground Articulated Trucks{4268, 4306, 5073, 5083, 5085}

Usage:

AD30 DXR
Underground Articulated Truck:
AD30 (S/N: DXR1-UP)

Introduction

The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.

Problem

Field service reports indicate that the 289-3530 Gear Pump Gp may fail.

Solution

Caterpillar is aware of the problem, but an interim repair has not yet been defined.

For a failed 289-3530 Gear Pump Gp refer to the instruction below.

  • Submit a Service Information Management System (SIMS) report

  • Submit a Dealer Solution Network (DSN) ticket quoting CPI number 320878

  • Request that the Tier 1 representative, transfer your ticket to an available Tier 2 representative for Caterpillar Underground Mining - Base Machine




Illustration 1g03651403

Location of the 289-3530 Gear Pump Gp

Caterpillar Information System:

D6N Track-Type Tractor Ripper Tip and Shank Protector - Inspect/Replace - If Equipped
953K and 963K Track-Type Loaders Hydrostatic Transmission and Hydraulic System Filters - Replace
953K and 963K Track-Type Loaders Hydraulic Tank Breather - Replace
953K and 963K Track-Type Loaders Hydraulic System Oil Level - Check
953K and 963K Track-Type Loaders Hydraulic System Oil - Change
844K Wheel Dozer Relay - Test
844K Wheel Dozer Operator Control Switch (Switch to Ground) - Test
844K Wheel Dozer Sensor Supply - Test
844K Wheel Dozer Wiring Harness (Short Circuit) - Test
844K Wheel Dozer Wiring Harness (Open Circuit) - Test
953K and 963K Track-Type Loaders Fuel Tank Water and Sediment - Drain
953K and 963K Track-Type Loaders Fuel Tank Cap and Strainer - Clean
2014/07/07 New Fan Hose Clamp Support Bracket Now Used on AD55B and AD60 Underground Articulated Trucks {5057}
390F Excavator Machine System Stick - 4.4 m (14.44 ft)
390F Excavator Machine System Stick - 2.9 m (9.51 ft)
390F Excavator Machine System Stick - 3.4 m (11.15 ft)
980M and 982M Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Output Transfer Gears
980L Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Transmission Planetary
390F Excavator Machine System Bucket Cylinder
990K Wheel Loader Machine Systems Input Transfer Gears - Adjust
D6R2 Track-Type Tractor Fuel System - Prime
980L Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Transmission Planetary
926M, 930M and 938M Wheel Loaders Additional Messages
2014/04/18 New Hose Assembly for the Pilot Lines Group Is Now Used on Certain D6R Track-Type Tractors {5057}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.