Clutch (Front Wheel Assist)
Show/hide table
Illustration 1 | g01317227 |
Show/hide table
Illustration 2 | g01317536 |
Section A-A |
(1) Tighten the bolt to the following torque. ... 105 ± 20 N·m (77 ± 15 lb ft)
(2) 161-8284 Wave Spring
- Number of turns ... 11
- Number of waves per turn ... 3.5
- Inside diameter of the spring ... 67.04 ± 0.64 mm (2.639 ± 0.025 inch)
- Free length of the spring ... 40.67 mm (1.601 inch)
- Test force that is required to compress the spring to 34.59 mm (1.362 inch) in length. ... 987 ± 155 N (222 ± 35 lb)
- Test force that is required to compress the spring to 31.09 mm (1.224 inch) in length. ... 1558 ± 155 N (350 ± 35 lb)
- Number of waves per turn ... 3.5
(3) 8E-6115 Plate
- Quantity ... 9
- Thickness of a new plate ... 2.12 ± 0.08 mm (0.084 ± 0.003 inch)
(4) 6Y-7922 Friction Disc
- Quantity ... 9
- Thickness of a new friction disc ... 4.00 ± 0.08 mm (0.158 ± 0.003 inch)
Caterpillar Information System:
TA19-M2WD and TA19-M4WD Agricultural Transmissions Visual Inspection
C0.5 and C0.7 Industrial Engines Fuel System Primary Filter/Water Separator - Drain
3500C Marine Propulsion Engines Component Location
3500C Marine Auxiliary Engines System Overview
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Crankshaft Wear Sleeve (Rear) - Remove and Install
TA19-M2WD and TA19-M4WD Agricultural Transmissions General Information
TA19-M2WD and TA19-M4WD Agricultural Transmissions Relief Valve (Transmission Lubrication)
345C Excavator Machine System Specifications Swing Gear and Bearing
C0.5, C0.7, C1.1, C1.5, C1.6 and C2.2 Industrial Engines Basic Engine
TA19-M2WD and TA19-M4WD Agricultural Transmissions Transmission Clutch
G3304 and G3306 Engines Turbocharger
C0.5, C0.7, C1.1, C1.5, C1.6 and C2.2 Industrial Engines Engine Oil and Filter - Change
2006/10/16 New Information Has Been Added in Testing and Adjusting , "Position Switch (Service Brake Pedal) - Adjust" {4269}
C32 Power Module Plate Locations and Film Locations
C7 On-highway Engine Engine to Transmission Adapter
C0.5, C0.7, C1.1, C1.5, C1.6 and C2.2 Industrial Engines Reference Material
C7 On-highway Engine Engine to Transmission Adapter
C7 On-highway Engine Engine to Transmission Adapter
C0.5, C0.7, C1.1, C1.5, C1.6 and C2.2 Industrial Engines Fuel System Secondary Filter - Replace
C18 Generator Set Overhaul (Top End)
3500C Marine Auxiliary Engines Electrical Connectors
3500C Marine Propulsion Engines Configuration Parameters
C280-12 and C280–16 Marine Engines Cylinder Head - Assemble
C15 and C18 Petrolem Generator Set Engines Acceleration Is Poor or Throttle Response Is Poor