Solenoid and Relief Valve (Output Transfer Gears) - Drop Box) (12 Volt
Show/hide table
 | |
| Illustration 1 | g01299865 |
(1) Inlet screen | |
Fluid filtration ... 10 Microns
Valve nominal pressure rating ... 3100 kPa (450 psi)
Operating temperature range ... -40 °C to 105 °C (-40 °F to 221 °F)
TH31 control line pressure at 1900 rpm (TH31) ... 1792 ± 138 kPa (260 ± 20 psi)
TH35 control line pressure at 1900 rpm (TH35) ... 2482 ± 138 kPa (360 ± 20 psi)
Caterpillar Information System:
C0.5, C0.7, C1.1, C1.5, C1.6 and C2.2 Industrial Engines Fuel System - Prime
C280-12 and C280–16 Marine Engines Cylinder Head - Remove
3516C Locomotive Engine Speed Sensor - Clean/Inspect
3500 Engines Fumes Disposal System
3516C Locomotive Engine Engine Air Cleaner Service Indicator - Inspect
3516C Locomotive Engine Starting Motor - Inspect
2006/08/21 A Improved Alternator Guard in Used {7174}
621G, 623G, 627G, 631G, 637G, and 657G Wheel Tractor-Scrapers Power Train Electronic Control System Service Tools
C280-12 and C280–16 Marine Engines Fuel Injector - Install
C280-12 and C280–16 Marine Engines Fuel Injector - Remove
TH31-C9I, TH31-C9P, TH31-C9T, TH35-C11I, TH35-C13I, TH35-C13T, TH35-C15I and TH35-C15T Petroleum Power Train Packages and TH31-E61 and TH35-E81 Petroleum Transmissions Power Train Electronic Control System MID 027 - CID 1823 - FMI 04
TH31-C9I, TH31-C9P, TH31-C9T, TH35-C11I, TH35-C13I, TH35-C13T, TH35-C15I and TH35-C15T Petroleum Power Train Packages and TH31-E61 and TH35-E81 Petroleum Transmissions Power Train Electronic Control System MID 027 - CID 1823 - FMI 03
2006/09/11 A New Clamp for the Air Cleaner is Used {1051}
307D, 311D, 312D, 313D, 315D, 318D, 319D, 320D, 323D, 324D, 325D, 326D, 328D, 329D, 330D, 336D, 340D, 345D, 349D, 374D, 390D and M325D Excavators Air Conditioning and Heating Actuator (Air Conditioner Control)
2007/10/01 Correct Installation Procedure for the 235-1448 Tube As {1304, 1306}
CX31 On-Highway Transmission Power Train Pump Drive - Remove - Rear PTO Shaft
2006/09/04 A New Torque Specification For the Cap Nuts on Fuel Injectors is Now Used {1120, 1290, 1408}
2006/10/23 Improved Head Gasket {1100, 1124}
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys 4 Wire Out Voltage - Calibrate
C175-16 Locomotive Engine ECM - Replace
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys In Current - Calibrate
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys AC Output Current - Calibrate
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys 4 Wire Output Current - Calibrate
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Flywheel DC Bus Voltage - Calibrate