Manual Barring Group - Install
安装步骤
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将手动盘机组件 (2) 在后壳体上放好。
注: 在安装手动盘机组件期间，支架组件可能对偏。 用手拧紧螺栓 (1) 。 操作把手和轴，以定位支架组件。 然后拧紧螺栓 (1) 。
Show/hide table
 | |
| 图 1 | g01297397 |
- 安装将手动盘机组件 (2) 固定入位的螺栓 (1) 。
- 将空气管 (3) 连接到手动盘机组件 (2) 。
Caterpillar Information System:
3612 and 3616 Engines Manual Barring Group - Remove
C32 Power Module Product Description
C27 and C32 Industrial Engines Electronic Unit Injector - Remove
C13 Engine Clean Gas Induction Pressure Sensor - Remove and Install
3606 and 3608 Engines Housing (Rear) - Install
C15 On-Highway Engine ARD Combustion Air Pressure Sensor - Remove and Install - Differential Pressure
C7 Engines for Caterpillar Built Machines Piston Cooling Jet
C7 Engines for Caterpillar Built Machines Piston Cooling Jet
390F Excavator Machine Systems Swing Drive - Assemble
3606 and 3608 Engines Housing (Rear) - Remove
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys DC Bus Voltage - Calibrate
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Controller Board Battery - Replace
C11 and C13 Engines Belt Tensioner
C11 and C13 Engines and 14M and 16M Motor Graders Diagnostic Trouble Code List
C11 and C13 Engines and 14M and 16M Motor Graders Event Code List
C27 and C32 Industrial Engines Electronic Unit Injector - Install
C7 and C9 On-Highway Engines Retarder - Test
C15 Petroleum Generator Set Engines Coolant Temperature Sensor
C13 and C15 On-highway Engines Factory Passwords
C15 Petroleum Generator Set Engines Inlet Air Temperature Sensor
C-9 Engines for Caterpillar Built Machines Speed/Timing Sensor
C13 and C15 On-highway Engines Speed Control (Auxiliary) - Test
2006/08/01 New Fuel Requirements for 2007 Low Emission Engines {1000, 1250}
TH31-C9I, TH31-C9P, TH31-C9T, TH35-C13I, TH35-C13T, TH35-C15I and TH35-C15T Petroleum Power Train Packages and TH31-E61 and TH35-E81 Petroleum Transmissions Transmission Output Transfer Gear Group - Drop Box