Electronic Unit Injector - Remove
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 5F-4764 | Pry Bar | 1 |
Start By:
- Remove the rocker arms and the rocker arm shaft. Refer to Disassembly and Assembly, "Rocker Arm and Shaft - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assembly (1).
- Remove bridge assemblies (3).
Show/hide table
NOTICE If the injector hold down bolt is loose during the removal procedure, inspect the injector bore for wear and debris. Replace the clamp and spacer.
- Remove bolt (4), spacer (5), and clamp (6).
- Place an identification mark on electronic unit injectors (2) for installation purposes. Each electronic unit injector must be reinstalled in the original location in the cylinder head.
Show/hide table
Illustration 2 g01297508 - Use Tooling (A) to pry beneath the base and free electronic unit injector (2).
- Remove electronic unit injector (2) from the cylinder head.
Show/hide table
Illustration 1 | g01297315 |
Caterpillar Information System:
C13 Engine Clean Gas Induction Pressure Sensor - Remove and Install
3606 and 3608 Engines Housing (Rear) - Install
C15 On-Highway Engine ARD Combustion Air Pressure Sensor - Remove and Install - Differential Pressure
C7 Engines for Caterpillar Built Machines Piston Cooling Jet
C7 Engines for Caterpillar Built Machines Piston Cooling Jet
390F Excavator Machine Systems Swing Drive - Assemble
3606 and 3608 Engines Housing (Rear) - Remove
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys DC Bus Voltage - Calibrate
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Controller Board Battery - Replace
C7 Engines for Caterpillar Built Machines Crankshaft Seals
390F Excavator Machine Systems Swing Drive - Disassemble
C1.5 and C2.2 Engines for Caterpillar Built Machines Fan Drive
C32 Power Module Product Description
3612 and 3616 Engines Manual Barring Group - Remove
3612 and 3616 Engines Manual Barring Group - Install
C11 and C13 Engines Belt Tensioner
C11 and C13 Engines and 14M and 16M Motor Graders Diagnostic Trouble Code List
C11 and C13 Engines and 14M and 16M Motor Graders Event Code List
C27 and C32 Industrial Engines Electronic Unit Injector - Install
C7 and C9 On-Highway Engines Retarder - Test
C15 Petroleum Generator Set Engines Coolant Temperature Sensor
C13 and C15 On-highway Engines Factory Passwords
C15 Petroleum Generator Set Engines Inlet Air Temperature Sensor
C-9 Engines for Caterpillar Built Machines Speed/Timing Sensor