Electronic Control Module - Remove and Install
Removal Procedure
- Disconnect the battery. Refer to Operation and Maintenance Manual, "Battery or Battery Cable - Disconnect".
Show/hide table
When servicing or repairing electric power generation equipment: Make sure the unit is off-line (disconnected from utility and/or other generators power service), and either locked out or tagged DO NOT OPERATE. Remove all fuses. |
- Disconnect harness assemblies (4) from electronic control module (3) .
Show/hide table
Illustration 1 | g01257238 |
- Disconnect ground strap (1) .
- Remove bolts (2), the mounts, the spacers, and electronic control module (3) .
- If necessary, remove bolts (6) and bracket (5) .
Installation Procedure
- If necessary, position bracket (5) and install bolts (6) .
Show/hide table
Illustration 2 | g01257238 |
- Install electronic control module (3), the spacers, the mounts, and bolts (2) .
- Connect grounding strap (1). Position ground strap (1) between the bolt head and the washer.
- Connect harness assemblies (4) to electronic control module (3) .
- Connect the battery. Refer to Operation and Maintenance Manual, "Battery or Battery Cable - Disconnect".
Caterpillar Information System:
C7 On-Highway Engine Turbocharger - Remove
C7 PETROLEUM Petroleum Engine Engine Oil Filter Base - Install
C7 On-highway Engine Fuel Filter Base
C7 PETROLEUM Petroleum Engine Engine Oil Filter Base - Assemble
G3500 A3 Engines Engine Governing - Adjust
2006/03/27 Sealing and Installing the Flywheel Housing {1157, 7555}
C7 On-Highway Engine Clean Gas Induction Valve - Remove
C7 PETROLEUM Petroleum Engine Engine Oil Filter Base - Disassemble
C15 Industrial Engine Powertrain Data Link Circuit - Test
AccuGrade® GPS (CD700) Sensor Firmware Upgrade
AccuGrade® GPS (CD700) Display Firmware Upgrade
AccuGrade® GPS (CD700) Receiver Firmware Upgrade
C280 Marine Propulsion Engines User Defined Shutdown Input
C15 On-Highway Engine Clean Gas Induction Valve - Disassemble
C15 On-Highway Engine Clean Gas Induction Valve - Assemble
C7 On-highway Engine Crankshaft Pulley
G3500 A3 Engines Oxygen Sensor - Calibrate
G3500 A3 Engines Measuring Exhaust Temperature
C7 PETROLEUM Petroleum Engine Water Pump - Remove
G3500 A3 Engines Measuring Engine Oil Pressure
C7 On-highway Engine Air Inlet Elbow
Installing Injectors on the 3116, 3116T, and 3126 Industrial Engines{1290} Installing Injectors on the 3116, 3116T, and 3126 Industrial Engines{1290}
C7 On-highway Engine Air Inlet Elbow
C7 On-highway Engine Air Inlet Elbow