Fuel Filter Base
Show/hide table
Illustration 1 | g01257121 |
(1) Apply 155-0695 Thread Lock Compound on the tapered end of the stud to the following distance. ... 7.6 ± 1.5 mm (0.30 ± 0.06 inch)
(2) Distance from the sealing surface of the filter base to the end of the stud ... 24.6 ± 1.3 mm (0.97 ± 0.05 inch)
(3) Plug
(4) Torque for stud ... 68 ± 7 N·m (50 ± 5 lb ft)
Show/hide table
Illustration 2 | g01257122 |
(5) O-ring seal
(6) Torque for cover ... 27 ± 3 N·m (20 ± 2 lb ft)
(7) Plug
Caterpillar Information System:
C7 PETROLEUM Petroleum Engine Engine Oil Filter Base - Assemble
G3500 A3 Engines Engine Governing - Adjust
2006/03/27 Sealing and Installing the Flywheel Housing {1157, 7555}
C7 On-Highway Engine Clean Gas Induction Valve - Remove
C7 PETROLEUM Petroleum Engine Engine Oil Filter Base - Disassemble
C15 Industrial Engine Powertrain Data Link Circuit - Test
AccuGrade® GPS (CD700) Sensor Firmware Upgrade
AccuGrade® GPS (CD700) Display Firmware Upgrade
AccuGrade® GPS (CD700) Receiver Firmware Upgrade
G3500 A3 Engines General Information (Electronic Control System)
G3500 A3 Engines Grounding Practices
C7 PETROLEUM Petroleum Engine Engine Oil Filter Base - Remove
C7 PETROLEUM Petroleum Engine Engine Oil Filter Base - Install
C7 On-Highway Engine Turbocharger - Remove
G3508, G3512 and G3516 Engines Electronic Control Module - Remove and Install
C280 Marine Propulsion Engines User Defined Shutdown Input
C15 On-Highway Engine Clean Gas Induction Valve - Disassemble
C15 On-Highway Engine Clean Gas Induction Valve - Assemble
C7 On-highway Engine Crankshaft Pulley
G3500 A3 Engines Oxygen Sensor - Calibrate
G3500 A3 Engines Measuring Exhaust Temperature
C7 PETROLEUM Petroleum Engine Water Pump - Remove
G3500 A3 Engines Measuring Engine Oil Pressure
C7 On-highway Engine Air Inlet Elbow