Crankshaft Rear Seal and Wear Sleeve - Remove
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 1U-8145     | Drill Bit     | 1     |
B     | 1U-7600     | Slide Hammer Puller Gp     | 1     |
C     | 4C-4869     | Distorter Ring     | 1     |
D     | 5P-7312     | Seal Distorter     | 1     |
Start By:
- Remove the flywheel. Refer to Disassembly and Assembly, "Flywheel - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use Tooling (A) and drill three evenly spaced holes in the crankshaft rear seal.
- Use Tooling (B) to remove crankshaft rear seal (1) .
Show/hide table
Illustration 1 | g01237688 |
- Use Tooling (C) and Tooling (D) in order to remove the wear sleeve (if equipped).
Note: New engines from the factory do not have a wear sleeve. Engines with seals that have been replaced will be equipped with a wear sleeve.
Caterpillar Information System:
G3500 A3 Engines Electronic Service Tool Will Not Communicate with ECM
G3500 A3 Engines Symptoms
C15 and C18 Generator Set Engines Engine Oil Filter Base - Remove
3126B and 3126E Truck Engines Air Compressor - Midland Air Compressors
2006/02/01 Troubleshooting Engines with Mechanical Unit Injection (MUI) {1290, 7569}
G3500 A3 Engines Replacing the ECM
2006/02/13 Enhanced Voltmeter Leads Are Now Available {0785}
3126B and 3126E Truck Engines Air Compressor - Midland Air Compressors
Procedure for Testing the 167-1709 Pressure Sensor Gp on the 3126 Industrial Engine{1718, 1916, 1917, 1923, 1924, 1925} Procedure for Testing the 167-1709 Pressure Sensor Gp on the 3126 Industrial Engine{1718, 1916, 1917, 1923, 1924, 1925}
C3.3 Industrial Engine Fuel Injector - Remove
C3.3 Industrial Engine Air in Fuel - Test
C15 and C18 Generator Set Engines Exhaust Manifold - Remove and Install
3126B and 3126E Truck Engines Air Compressor - Midland Air Compressors
C15 and C18 Generator Set Engines Engine Oil Filter Base - Install
C7 Marine Engines Crankshaft Rear Seal and Wear Sleeve - Install
3500 Spark Ignited Engines Spark Plug and Transformer
2006/02/13 Test Harness Connects PC or Laptop Computer to Electronic Governor {0779, 0785, 1930, 7620}
G3500 A3 Engines Engine Starts but Stalls Immediately
C3.3 Industrial Engine Engine Crankcase Pressure (Blowby) - Test
C15 and C18 Generator Set Engines Engine Oil Filter Base - Disassemble
Inspection and Repair Procedures for Wheels that are Used on Off-Highway Trucks {4201, 4201, 4201} Inspection and Repair Procedures for Wheels that are Used on Off-Highway Trucks {4201, 4201, 4201}
C3.3 Industrial Engine Engine Oil Pressure - Test
C15 and C18 Generator Set Engines Engine Oil Filter Base - Assemble
C3.3 Industrial Engine Fuel Injection Nozzle - Test