Aftercooler Core - Clean/Test
- 将后冷器芯倒置,以便倒掉碎屑。
- 用清洁剂反向冲洗芯。
Caterpillar 建议使用 Hydrosolv 液体清洁剂。 表 1 中列出了可在 Caterpillar 代理商处获得的 Hydrosolv 液体清洁剂。
Show/hide table表 1 Hydrosolv 液体清洁剂 (1)     说明     容器     1U-5490 Hydrosolv 4165    
19 L (5 US gal)    174-6854 Hydrosolv 100    
19 L (5 US gal)    Show/hide table( 1 ) 在不高于 93°C (200°F) 的温度下,用浓度为 2% - 5% 的清洗剂进行清洗。 有关更多信息,请参阅应用指南, NEHS0526或咨询当地的 Caterpillar 代理商。
Show/hide table
注意 |
---|
不要用高浓度的腐蚀性清洁剂来清洗芯子。 高浓度腐蚀性清洁剂会腐蚀芯子内部的金属从而引起渗漏。 只使用推荐浓度的清洗剂。 |
- 用蒸汽清洗芯,以便清除所有残留物。 冲洗后冷器芯的散热片。 去除所有其他残留的碎屑。
- 用热的肥皂水清洗芯。 用清水彻底冲洗芯。
- 用压缩空气吹干芯。 让空气向正常流动的相反方向吹。
Show/hide table
高压空气会造成人身伤害。 不按下面的适当步骤进行操作会造成人身伤害。 使用压缩空气时,戴防护面罩及穿防护服。 用做清洗用途时,喷嘴处最大空气压力必须低于205 kPa (30 psi) 。 |
- 检查芯以确保清洁。 对芯进行压力测试。 许多配备维修用散热器的车间都能进行压力测试。 如有必要,修理后冷却器芯。
- 安装芯。 有关步骤,请参阅维修手册。
有关清洁芯的更多信息,请咨询当地的 Caterpillar 代理商。
Caterpillar Information System:
C15 and C18 Generator Set Engines Fuel Filter Base - Disassemble
C3.3 Industrial Engine Engine Oil Pump - Inspect
C3.3 Industrial Engine Valve Guide - Inspect
3512 Industrial Engine Fuel System Operation
C15 and C18 Generator Set Engines Fuel Filter Base - Remove
330B Excavator Machine System Specifications Front Idler
C6.6 Engines for Caterpillar Built Machines Starter Motor
2006/02/01 Responsibilities for Emission Certified Engines {1000}
3512B and 3512C Engines For Caterpillar Built Machines Electronic Control Module (ECM)
C280 Marine Propulsion Engines Event Code List
C15 and C18 Generator Set Engines Fuel Priming Pump - Remove and Install
C6.6 Engines for Caterpillar Built Machines Flywheel Housing
New Software for Cylinder Tests is Now Available{7620} New Software for Cylinder Tests is Now Available{7620}
C15 and C18 Generator Set Engines Fuel Filter Base - Assemble
C15 and C18 Generator Set Engines Fuel Filter Base - Install
C11 and C13 Engines Engine Oil Pressure Sensor
2006/01/23 Proper Identification of Ports on 5P-0306 Vacuum Transducer {0768, 5050, 5056}
2006/02/13 Disposable Dessicant Filter is Now Available {0618, 0646}
C280 Marine Propulsion Engines System Overview
Installation of the 225-4256 Film {7405, 7557} Installation of the 225-4256 Film {7405, 7557}
C15 and C18 Generator Set Engines Turbocharger - Remove
C15 and C18 Generator Set Engines Turbocharger - Install
3126B and 3126E Truck Engines Boost Pressure Sensor
C3.3 Industrial Engine Cooling System - Inspect