Engine Oil Filter Base
One-Piece Body
Show/hide table
Illustration 1 | g01156510 |
Two-Piece Body
Show/hide table
Illustration 2 | g01156511 |
(1) The bypass valve spring is located in the filter bypass valve:
- Outside diameter ... 11.0 mm (0.43 inch)
- Free length ... 58.50 ± 0.50 mm (2.303 ± 0.020 inch)
- Assembled length ... 43.18 mm (1.70 inch)
- Load at assembled length ... 43.7 N (9.82 lb)
- Free length ... 58.50 ± 0.50 mm (2.303 ± 0.020 inch)
(2) The oil filter bypass valves must open at the following pressure. ... 125 ± 30 kPa (18.1 ± 4.4 psi)
(3) Prior to installing the stud into the engine oil filter base, apply 9S-3263 Thread Lock Compound to the base end of the stud. Length ... 7.5 ± 1.5 mm (0.30 ± 0.06 inch)
Tighten the stud to the following torque. ... 68 ± 7 N·m (50 ± 5 lb ft)
(4) Use clean engine oil to lubricate the oil filter's seal. Tighten the filter until the seal contacts the base. Hand tighten the filter for an additional 3/4 turn (270 degrees).
Caterpillar Information System:
TH48-E80 Petroleum Transmission Relief Pressures for Control Manifold - Testing and Adjusting
C3.3 Industrial Engine Exhaust Manifold - Remove and Install
C3.3 Industrial Engine Turbocharger - Install
3126B and 3126E Truck Engines Camshaft
C3.3 Industrial Engine Turbocharger - Remove
C3.3 Industrial Engine Fuel Injection Pump - Install - Delphi DP210
C3.3 Industrial Engine Water Temperature Regulator and Housing
C3.3 Industrial Engine Fuel Injection Pump - Remove - Delphi DP210
C3.3 Industrial Engine Fuel Injector Cover - Remove and Install - If Equipped
C3.3 Industrial Engine Crankcase Breather
C7 and C9 Marine Engines CID 0006 FMI 11 Cylinder #6 Injector fault
C3.3 Industrial Engine Fuel Injection Lines - Install
3500 Locomotive Engines Pressure Gauge
2008/07/14 Coolant Level Sensor Installation Service Notes {5574}
2008/07/07 Coolant Sensor Installation Service Notes {5574}
2005/12/19 The New Low Gas Pressure Module is Now Available {1901}
C175 Generator Set Engines Connecting Rod Bearings - Remove and Install
C3.3 Industrial Engine Crankshaft Seals
C6.6 Engines for Caterpillar Built Machines Gear Group (Front)
C9 Generator Set Engine Engine Enclosure Group - Install
C7 On-highway Engine Engine Oil Pan
C9 Generator Set Engine Muffler - Remove and Install
Reuse Specifications for 3600 Combustion Gaskets {0762, 0763, 1100, 1124, 1201} Reuse Specifications for 3600 Combustion Gaskets {0762, 0763, 1100, 1124, 1201}
3512B Oil Well Servicing Engine (ADEM III) Air Shutoff System