Water Temperature Regulator and Housing
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 207-1601 | Rubber Lubricant | 1 |
Tighten the bolts (not shown) that fasten the housing to the following torque. ...
Show/hide table
Illustration 1 | g00997234 |
O ring |
Note: ApplyTooling (A) to the O-ring (1) in order to install the thermostat housing.
Opening temperature ...
Full opening temperature ...
Minimum stroke at full open temperature ...
Caterpillar Information System:
C3.3 Industrial Engine Fuel Injection Pump - Remove - Delphi DP210
C3.3 Industrial Engine Fuel Injector Cover - Remove and Install - If Equipped
C3.3 Industrial Engine Crankcase Breather
C7 and C9 Marine Engines CID 0006 FMI 11 Cylinder #6 Injector fault
C3.3 Industrial Engine Fuel Injection Lines - Install
C7 and C9 Marine Engines CID 0005 FMI 11 Cylinder #5 Injector fault
C3.3 Industrial Engine Cylinder Head Valves
TH48-E80 Petroleum Transmission Gear Pump (Transmission)
C7 and C9 Marine Engines CID 0004 FMI 11 Cylinder #4 Injector fault
C7 and C9 Marine Engines CID 0003 FMI 11 Cylinder #3 Injector fault
C7 and C9 Marine Engines CID 0002 FMI 11 Cylinder #2 Injector fault
C7 and C9 Marine Engines CID 0001 FMI 11 Cylinder #1 Injector fault
C3.3 Industrial Engine Fuel Injection Pump - Install - Delphi DP210
C3.3 Industrial Engine Turbocharger - Remove
3126B and 3126E Truck Engines Camshaft
C3.3 Industrial Engine Turbocharger - Install
C3.3 Industrial Engine Exhaust Manifold - Remove and Install
TH48-E80 Petroleum Transmission Relief Pressures for Control Manifold - Testing and Adjusting
3126B and 3126E Truck Engines Engine Oil Filter Base
3500 Locomotive Engines Pressure Gauge
2008/07/14 Coolant Level Sensor Installation Service Notes {5574}
2008/07/07 Coolant Sensor Installation Service Notes {5574}
2005/12/19 The New Low Gas Pressure Module is Now Available {1901}
C175 Generator Set Engines Connecting Rod Bearings - Remove and Install