Start By:
- Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
- Release the hydraulic system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".
Note: Cleanliness is an important factor. Before the disassembly procedure, thoroughly clean the exterior of the component . This action will help to prevent dirt from entering the internal mechanism.
Note: Put identification marks on all lines, on all hoses, on all harness assemblies, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This action helps to prevent fluid loss and also helps to keep contaminants from entering the system.
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
 |
|
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
- Remove guard assembly (1).
Show/hide table
Illustration 2 g03142125 - Remove guard assembly (2) .
Show/hide table
Illustration 3 g03142316 - Disconnect hose assemblies (3), (4), and (5).
- Disconnect harness assembly (6).
Show/hide table
Illustration 4 g03142202 Show/hide table
Illustration 5 g03142177 - Disconnect tube assembly (9) and clip (8).
- Attach a suitable lifting device to winch (10). The weight of winch (10) is approximately
340 kg (750 lb) . - Remove bolts (7) and winch (10).
| |
| Illustration 1 | g03141956 |
