Solenoid Valve (Negative Flow Control, Proportional Reducing Valve) - Assemble
- 安装螺母 (11)。 拧紧螺母 (11),使其扭矩达到
4.9 ± 0.5 N·m (43 ± 4 lb in) 。 安装 O 形密封圈 (12) 和 O 形密封圈 (13)。Show/hide table图 2 g01210344 - 安装 O 形密封圈 (6)、 (8) 和 (9)。 安装支承环 (5)、 (7) 和 (10)。 对其余的阀总成重复上述步骤。
Show/hide table
图 3 g01210343 - 安装阀总成 (1) 和螺栓 (2)。 拧紧螺栓 (2),使其扭矩达到
6.9 ± 0.7 N·m (61 ± 6 lb in) 。 安装阀总成 (3)。 拧紧阀总成 (3) 至扭矩为47.5 ± 2.5 N·m (35 ± 2 lb ft) 。 安装六个螺塞 (4)。 拧紧六个螺塞 (4) 至扭矩为6.9 ± 1.0 N·m (61 ± 9 lb in) 。
Show/hide table
图 1 | g01210350 |
结束:
- 安装电磁阀(反向流量控制、比例减压阀)。 请参阅拆解和组装, "电磁阀(反向流量控制、比例减压阀)- 安装"。
Caterpillar Information System:
330D, 336D, 336D2, 340D and 340D2 Excavators and 336D MHPU Mobile Hydraulic Power Unit Machine Systems Solenoid Valve (Negative Flow Control, Proportional Reducing Valve) - Disassemble
C7 Petroleum Engines Exhaust Elbow
C7 Petroleum Engines Exhaust Elbow
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Solenoid Valve (Negative Flow Control, Proportional Reducing Valve) - Install
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Solenoid Valve (Negative Flow Control, Proportional Reducing Valve) - Remove
C27 and C32 Engines for Caterpillar Built Machines CID 0190 FMI 08 Engine Speed signal abnormal
C27 and C32 Generator Set Engines System Configuration Parameters
C27 and C32 Generator Set Engines E197 High Engine Oil Temperature
C175 Generator Set Engines Water Temperature Control Valve - Remove
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Stick - Install
C27 and C32 Generator Set Engines CAN Data Link Circuit - Test
C7 Engines for Caterpillar Built Machines Exhaust Manifold
TH31 Well Servicing Transmissions Bypass Valve - Remove and Install
C7 Petroleum Engines Engine Oil Lines
CX31 On-Highway Transmission Modulating Valve
C7 Petroleum Engines Water Lines
C15 and C18 Engines for Caterpillar Built Machines Piston Cooling Jet
TH31-C9I, TH31-C9P, TH31-C9T, TH35-C13I, TH35-C13T, TH35-C15I and TH35-C15T Petroleum Power Train Packages and TH31-E61 and TH35-E81 Petroleum Transmissions Transmission Oil Filter (Transmission)
C7 Engines for Caterpillar Built Machines Flywheel
C175 Generator Set Engines Water Temperature Control Valve - Install
C175 Generator Set Engines Electronic Control Module (Engine) - Remove and Install
TH48-E80 Petroleum Transmission General Information
TH31 Well Servicing Transmissions Modulating Valve (Transmission Clutch) - Remove and Install
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Swing Gear and Bearing - Remove