Front Cover - Install
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 154-9731     | Thread Lock Compound     | -     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean the mating surfaces of the front housing and front cover (5) .
Show/hide table
Illustration 1 | g01193110 |
- Install a new gasket and front cover (5) .
- Install bolts (3) .
- Apply Tooling (A) to the threads of stud (6). Install the nut on stud (6) .
- Install nut (4). Tighten the nut to a torque of 35 ± 5 N·m (26 ± 4 lb ft).
- Install engine lifting bracket (2) and bolts (1) .
Show/hide table
Illustration 2 | g01193105 |
Caterpillar Information System:
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Throttle Switch Circuit - Test
C4.4 and C6.6 Engines for Caterpillar Built Machines ECM Memory - Test
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Engine Mount - Remove - Rear
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Engine Mount - Install - Front
3412E Petroleum Engine Front Cover - Remove
2005/08/22 Improved Gasket for the Jacket Water Pump {1361}
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0826 - FMI 03
2005/08/15 New Torque Procedure for the Exhaust Elbow {1061}
3412E Petroleum Engine Vibration Damper and Pulley - Remove and Install
2005/08/15 Improved Ignition Transformers are Used {4476}
3412E Petroleum Engine Flywheel Housing - Remove and Install
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0672 - FMI 08
324D, 325D, 326D and 329D Excavators and 329D MHPU Mobile Hydraulic Power Unit Machine Systems Selector Valve (Alternate Pattern Control) - Disassemble
324D, 325D, 326D and 329D Excavators and 329D MHPU Mobile Hydraulic Power Unit Machine Systems Selector Valve (Alternate Pattern Control) - Assemble
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0826 - FMI 04
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Engine Mount - Install - Rear
C27 and C32 Engines for Caterpillar Built Machines CID 0174 FMI 03 Fuel Temperature open/short to +batt
C7.1 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
2005/08/01 An Improved Idler Pulley Has Been Released {1358}
3412E Petroleum Engine Crankcase Breather - Remove and Install
2005/08/15 An Improved Idler Pulley Has Been Released {1358}
Caterpillar On-Highway Diesel Engine Fluids Recommendations Characteristics of Diesel Fuel
TH48-E80 Petroleum Transmission Power Train Electronic Control System Electrical Component and Connector Locations
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Fuel Rail Pump Solenoid - Test