Steering Cylinder Bearings - Lubricate
Show/hide table
NOTICE |
---|
Check that the lines attached to all the remote grease fittings are undamaged. If the grease lines are split, grease will not reach the components that require lubricating. Machine damage will result. |
Wipe off the fittings before any lubricant is applied.
- Lubricate the right steering cylinder bearing in the head end of the steering cylinder through remote mounted fitting (1) .
Show/hide table
Illustration 1 | g00952584 |
- Lubricate the left steering cylinder bearing in the head end of the steering cylinder through remote mounted fitting (2) .
- Lubricate the left steering cylinder bearing in the rod end of the steering cylinder through remote mounted fitting (3) .
Show/hide table
Illustration 2 | g00952585 |
- Lubricate the right steering cylinder bearing in the rod end of the steering cylinder through remote mounted fitting (4) .
Caterpillar Information System:
2003/01/27 The Lockup Clutch May be Enabled or Disabled with Cat ET {0785, 3102}
D6N Track-Type Tractor Engine Supplement Engine - Install
D6N Track-Type Tractor Engine Supplement Engine - Remove
963C Track-Type Loader Monitoring System
3054E Industrial Engine Engine Oil Filter Base - Remove and Install
854G Wheel Dozer Transmission Oil Sample - Obtain
963C Track-Type Loader Operator Controls
D5N Track-Type Tractor Power Train Steering Clutch and Brake - Assemble
D5N Track-Type Tractor Power Train Steering Clutch and Brake - Disassemble
963C Track-Type Loader Seat
963C Track-Type Loader Daily Inspection
2003/02/03 Special Instruction, REHS1238, "Obtaining Factory Passwords and Software Enabled Attachments" is Available {7610}
AD45 and AE40 II Underground Articulated Trucks Steering Stop - Check
3054E Industrial Engine Engine Oil Cooler - Remove
AD45 and AE40 II Underground Articulated Trucks Steering Tank Screen - Clean
3054E Industrial Engine Engine Oil Cooler - Install
C13, C15, and C18 Tier 4 Final Engines Water Pump
3054E Industrial Engine Water Pump - Remove and Install
3406E Engine for Caterpillar Built Machines Analog Sensor Supply Circuit - Test
Supplement to the Operation and Maintenance Manual{0707} Supplement to the Operation and Maintenance Manual{0707}
950G Series II Wheel Loader, 962G Series II Wheel Loader and IT62G Series II Integrated Toolcarrier Machine Systems Lift Cylinder - Remove and Install
AD45 and AE40 II Underground Articulated Trucks Steering System Oil - Change
963C Track-Type Loader Engine Starting with Jump Start Cables
2003/01/27 Correct Polarity Is Required for Back-Up Alarm Functionality {7406}