Theft Deterrent Is Active
Note: The theft deterrent system is managed via the Caterpillar driver information display. The following code relates to the theft deterrent system:
Show/hide table
Diagnostic Trouble Codes for the Theft Deterrent System | ||
---|---|---|
J1939 Code | Description | Note |
224-11 | Theft Deterrent Active | The code that is displayed depends on the version of the engine software. |
224-14 | Theft Deterrent Active With Engine Cranking | |
1196-31 | Anti-theft Component Status States |
The code indicates the status of the system. The code is active only while the appropriate condition exists.
Engine Stopped
The engine will not start while the system is activated. The code is active. The check engine lamp is illuminated. If the engine is cranked, the code remains active. The engine will not start until the correct password is entered into the system.
Engine at Idle
Engine speed is limited to programmed low idle rpm while the theft deterrent system is activated. The code is active. The check engine lamp is illuminated. Engine speed will not increase above idle until the correct password is entered into the system.
Caterpillar Information System:
C13 and C15 On-highway Engines Quick Stop Occurrence
C13 and C15 On-highway Engines Exhaust Temperature Is High
C7 and C9 On-Highway Engines Engine Shutdown Override Occurrence
2005/07/04 New Gaskets for the Turbocharger Oil Lines are Now Used {1052, 1307}
C32 Petroleum Generator Sets Generator Start-up Checklist
C6.6 Engines for Caterpillar Built Machines Cylinder Block
C7 and C9 On-Highway Engines Component Location
3500 Generator Sets Starting with Jump Start Cables
C13 On-Highway Engines Cooling System
3412C Generator Set Electronic Modular Control Panel II+ (EMCP II+) - If Equipped
3412C Generator Set Electronic Modular Control Panel 3 (EMCP 3) - If Equipped
C13 On-Highway Engines Lubrication System
C13 and C15 On-highway Engines Vehicle Overspeeds
C7 and C9 On-Highway Engines Sensor Signal (Analog, Passive) - Test
C15 On-Highway Engine Turbocharger - Inspect
C13 and C15 On-Highway Engines Engine Electronics
C15 On-Highway Engine Fuel System Pressure - Test
3126B Petroleum Engine Fuel Filter Base - Remove and Install
C18 Generator Sets Sensors and Electrical Components
3126B Petroleum Engine Electronic Unit Injector - Remove
3126B Petroleum Engine Electronic Unit Injector - Install
C7 and C9 On-Highway Engines Fuel Injection Pump - Test
C32 Marine and Auxiliary Marine Engines Fuel Transfer Pump - Remove
120H and 135H Motor Graders Hydraulic and Steering System Relief Valve (Scarifier)