Air Inlet Heater - Install
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件描述 | 数量 |
A | 4C-9500 | 快速硫化底漆 | 1 |
B | 8C-8422 | 密封胶 | 1 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 用清洁剂清洁进气加热器 (7) 表面。 将工具 (A) 涂敷在进气加热器 (7) 的表面。 让工具 (A) 干躁 3 到 5 分钟。 在接合面上涂抹工具 (B),并均匀铺开。 必须在 10 分钟内安装并紧固进气加热器 (7)。
Show/hide table
图 2 g01271053 - 放置好进气弯头 (6)。 安装螺栓 (5)。
- 连接接地母带 (3) 并安装螺栓 (4)。
- 连接线束组件 (1)。
- 连接电缆组件 (2)。
- 将断路开关转到接通位置。
Show/hide table
图 1 | g01271055 |
Caterpillar Information System:
C4.4 Industrial Engine Monitoring System
C4.4 Industrial Engine Gauges and Indicators
2014/08/07 A New Fuel Transfer Pump Has Been Released {1256}
2005/05/23 A New Fuel Transfer Pump Has Been Released {1256}
C4.4 Industrial Engine Engine Electronics
G3500 Engines Air Starting Motor - Disassemble
C7 On-highway Engine Fuel System
C27 and C32 Industrial and Petroleum Engines Ether Injection System - Test
C7 On-highway Engine Fuel Injector - Test
C7 On-highway Engine Clean Gas Induction Cooler
C13 and C15 On-Highway Engines Compression Brake - If Equipped
C9 Generator Set Fuel System Primary Filter (Water Separator) Element - Replace
3500 Generator Sets Reference Material
793F Off-Highway Truck Differential Warm-up and Break-in
C9 Engine for Caterpillar Built Machines Engine Oil Filter Base and Oil Cooler - Remove
3406E Marine Engine Pistons and Connecting Rods - Disassemble
C4.4 Industrial Engine General Hazard Information
C4.4 Industrial Engine Burn Prevention
C4.4 Industrial Engine Engine Starting
3406E Marine Engine Pistons and Connecting Rods - Assemble
3500 Industrial and Generator Set Engines Magnetic Pickups - Clean/Inspect - If Equipped
C6.6 Industrial Engine Diagnostic Flash Code Retrieval
C4.4 Industrial Engine Before Starting Engine
C4.4 (Mech) Industrial Engine Starting with Jump Start Cables