Water Pump - Install
Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
- Install a new gasket (8) (not shown). Install water pump (3) in the original location. Install bolts (7) .
Show/hide table
Illustration 1 | g00829555 |
- Connect hose (5) and hose (6) on water pump (3). Tighten hose clamps (1), (2), and (4) on water pump (3) .
Show/hide table
Illustration 2 | g00829554 |
- Fill the cooling system. Refer to Operation and Maintenance Manual, SEBU7479, "Cooling System Level - Check" for the correct procedure.
End By: Install the fan and the fan guard. Refer to Disassembly and Assembly, "Fan and Fan Guard - Remove and Install" for the machine that is being serviced.
Caterpillar Information System:
3056 Engines Connecting Rod
2001/11/12 A New Rear Housing Assembly is Available {1157}
3056E Industrial Engine Camshaft
D3G, D4G and D5G Hystat Track-Type Tractors Engine Supplement Water Pump - Remove
3056 Engines Engine Oil Pump
621G and 623G Wheel Tractor Power Train Final Drive - Disassemble
966H and 972H Wheel Loaders Machine Systems Electrohydraulic Control - Remove
623G Wheel Tractor-Scraper Machine Systems Check Valve (Carry) - Disassemble
2001/10/29 Correction to Disassembly and Assembly , "Bucket-Install" {0645, 6101, 6102}
D10R Track-Type Tractor Power Train Chrome Bearing - Remove and Install
3176C, 3196 and 3406E Engines for Caterpillar Built Machines Engine Temperature Sensor Open or Short Circuit - Test
3176C, 3196 and 3406E Engines for Caterpillar Built Machines Digital Sensor Supply Circuit - Test
3056 Engines Cylinder Head
D6R Series II Track-Type Tractor Power Train Bevel and Transfer Gears - Disassemble
621G and 623G Wheel Tractor Power Train Final Drive - Assemble
621G and 627G Wheel Tractor-Scrapers Machine Systems Air Tank - Remove and Install
D6R Series II Track-Type Tractor Power Train Bevel and Transfer Gears - Assemble
D3G, D4G and D5G Track-Type Tractors Piston Pump (Hydrostatic)
966H and 972H Wheel Loaders Machine Systems Electrohydraulic Control - Install
Installation of Automatic Lubrication for the 966G and the 972G Wheel Loaders{7540} Installation of Automatic Lubrication for the 966G and the 972G Wheel Loaders{7540}
3126B Engines for the IT62G Series II Integrated Toolcarrier and for the 950G Series II and 962G Series II Wheel Loaders Low Power/Poor or No Response to Throttle
3176C, 3196 and 3406E Engines for Caterpillar Built Machines 5 Volt Engine Pressure Sensor Supply Circuit - Test
G3500B Engines Fumes Disposal Filter Differential Pressure - Check
2001/10/08 An Improved Accumulator Spring Assembly is Now Used in the Valves for the Electronic Brake (EB) and the Electronic Clutch/Brake (ECB) {5051}