Turbocharger
Show/hide table
Illustration 1 | g01149900 |
Note: The oil supply and the oil drain holes should be in the vertical position with respect to the engine when the turbocharger is attached to the exhaust manifold.
(1) Clamp
- Tighten the clamp for the turbine housing to the following torque. ...
14 ± 1 N·m (125 ± 9 lb in)
(2) Clamp
- Tighten the clamp for the compressor housing to the following torque. ...
10.2 ± 0.7 N·m (90 ± 6 lb in)
Gently hit around the V-band clamps with a soft faced hammer. Again tighten the V-band clamps to the above torques.
Note: Apply 5P-3931 Anti-Seize Compound to the stud threads on the exhaust manifold and to the faces of the washers and the nuts before assembly of the turbocharger.
(3) Tighten the Spiralock nuts that fasten the turbocharger to the exhaust manifold to the following torque. ...
Caterpillar Information System:
2005/03/01 The Cylinder Liners Have a New Appearance {1216}
C27 and C32 Generator Set Engines Connecting Rod Bearings - Install
3054E Industrial Engine Idler Gear (Front) - Remove
3054E Industrial Engine Crankshaft Wear Sleeve (Front) - Install
3054E Industrial Engine Crankshaft Wear Sleeve (Front) - Remove
3406E, C12, C15 and C18 Marine Engines Event Codes
C27 and C32 Generator Set Engines Connecting Rod Bearings - Remove
2005/03/14 The Cylinder Liners Have a New Appearance {1216}
2005/03/14 The Cylinder Liners Have a New Appearance {1216}
C27 and C32 Generator Set Engines Pistons and Connecting Rods - Install
C27 and C32 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Assemble
C27 and C32 Generator Set Engines Pistons and Connecting Rods - Remove
2005/03/01 New Serial Number Prefix {1000}
C27 and C32 Generator Set Engines Crankshaft Main Bearings - Remove
GENSET, SR4, SR4 HV, SR4B and SR4B HV Electric Power Generation, 3126, 3176B, 3176C, 3196, 3408E, 3412C, 3412E, 3508, 3508B, 3512, 3512B, 3516, 3516B and G3616 Engines, 3406E GEN SET Generator Set, 3406E IND, 3408C IND and 3456 IND Industrial Engines Sea Water Module Interface
C27 and C32 Generator Set Engines Crankshaft Main Bearings - Install
C7 and C9 Marine Engines Injection Actuation Pressure Control Valve Circuit - Test
C9 On-highway Engine Exhaust Manifold
C7 and C9 Engines for Caterpillar Built Machines Injection Actuation Pressure Control Valve Circuit - Test
784C and 785C Off-Highway Truck/Tractors Air Tank - Inspect
994F Wheel Loader Hydraulic System Electronic Control Module (ECM) - Replace
3054E Industrial Engine Idler Gear (Front) - Disassemble
3054E Industrial Engine Idler Gear (Front) - Assemble
3054E Industrial Engine Idler Gear (Front) - Install