Sea Water Module Interface
- With only the SWMI device connected to the PL1000T, observe the "GPSIM Statistics" screen. Use the service tool status screens in order to view the "GPSIM Statistics" information. Confirm that the "Total Number of NMEA-183 Messages Received" does increment. If the values do not regularly increment, then the data is not being reliably transmitted by the SWMI device. Refer to the troubleshooting documentation that is for the SWMI device in order to determine the reason why the values do not consistently increment.
- If the value for the total number of invalid or unsupported "NMEA-183" messages increment, this indicates the SWMI is not transmitting standard "NMEA-183" formatted messages. The PL1000T is only compatible with devices that adhere to the NMEA-183 standard messages. The sensing device should be replaced with a device that transmits standard NMEA-183 messages.
Problem-No SWMI Information Available on Cat Datalink or J1939
- Confirm that the "SWMI Endable Status" is set to "Enabled".
- Observe the "GPSIM Statistics" information with the use of the service tool status screens. Confirm that the PL1000T is regularly receiving NMEA-183 messages. If these statistics do not regularly increment, then the SWMI device is not reliably transmitting the data. Refer to the troubleshooting documentation that is for the SWMI device in order to determine the reason why the values do not consistently increment.
- If troubleshooting procedures for the SWMI device indicate no problems with that device, then the system harnessing should be analyzed and repaired.
SWMI Information is Available on Cat Datalink but not J1939
- The SWMI information that is available on Cat Datalink indicates that the SWMI feature is properly enabled. The system harnessing should be analyzed and repaired.
Caterpillar Information System:
C27 and C32 Generator Set Engines Crankshaft Main Bearings - Remove
2005/03/01 New Serial Number Prefix {1000}
C9 Generator Set Engines Turbocharger
2005/03/01 The Cylinder Liners Have a New Appearance {1216}
C27 and C32 Generator Set Engines Connecting Rod Bearings - Install
3054E Industrial Engine Idler Gear (Front) - Remove
3054E Industrial Engine Crankshaft Wear Sleeve (Front) - Install
3054E Industrial Engine Crankshaft Wear Sleeve (Front) - Remove
3406E, C12, C15 and C18 Marine Engines Event Codes
C27 and C32 Generator Set Engines Connecting Rod Bearings - Remove
2005/03/14 The Cylinder Liners Have a New Appearance {1216}
2005/03/14 The Cylinder Liners Have a New Appearance {1216}
C27 and C32 Generator Set Engines Crankshaft Main Bearings - Install
C7 and C9 Marine Engines Injection Actuation Pressure Control Valve Circuit - Test
C9 On-highway Engine Exhaust Manifold
C7 and C9 Engines for Caterpillar Built Machines Injection Actuation Pressure Control Valve Circuit - Test
784C and 785C Off-Highway Truck/Tractors Air Tank - Inspect
994F Wheel Loader Hydraulic System Electronic Control Module (ECM) - Replace
3054E Industrial Engine Idler Gear (Front) - Disassemble
3054E Industrial Engine Idler Gear (Front) - Assemble
3054E Industrial Engine Idler Gear (Front) - Install
C27 and C32 Generator Set Engines Crankshaft - Remove
C9 Engines for Caterpillar Built Machines Unit Injector Hydraulic Pump - Remove
C3.3 and C4.4 Generator Sets Fuel System Secondary Filter - Replace