NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin. |
Illustration 1 | g00520484 |
The drain plug (1) for the transmission is located under the transmission.
Operate the machine until the transmission oil is warm. Park the machine on a level surface. Lower the bowl.
Engage the parking brake. Stop the engine.
- Clean the area around transmission drain plug (1).
- Remove transmission drain plug (1) and drain the oil into a suitable container.
- Clean transmission drain plug (1) and install transmission drain plug (1).
Show/hide table
Illustration 2 g00604341 - Clean the area around filler cap (2). Remove filler cap (2). Fill the transmission with oil through the filler tube. Fill the transmission to the "FULL" mark on dipstick (3). Refer to the Operation and Maintenance Manual, "Capacities (Refill)" and the Operation and Maintenance Manual, "Lubricant Viscosities".
- Clean filler cap (2). Install filler cap (2).
- Start the engine. Run the engine at low idle. Inspect the transmission for leaks.
- Slowly operate the transmission control in order to circulate the oil.
- Maintain the oil level between the "FULL" and "ADD OIL" marks on the dipstick (3). Add oil through the filler tube, if necessary.
- Stop the engine.