Suction Screen (Transmission Scavenge) - Clean
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| |
| Illustration 1 | g00604251 |
The suction screen is located at the right rear of the torque converter.
- Park the machine on level ground. Lower the bowl. Apply the parking brake. Shut off the engine. Open the engine compartment access door.
- Clean the area around the housing for the screen.
- Remove the nut and the screen. Allow the oil to drain into a suitable container.
- Clean the screen in nonflammable solvent. Inspect the screen for damage. Replace the screen if the screen is damaged.
- Inspect the seal. Replace the seal if the seal is damaged.
- Install the screen and the nut.
- Start the engine.
- Check the area around the screen housing for leaks.
- Check the transmission oil level. Add oil if oil is needed.
- Shut off the engine.
Caterpillar Information System:
613C Series II Wheel Tractor-Scraper Refrigerant Dryer - Replace
613C Series II Wheel Tractor-Scraper Hydraulic Tank Breaker Relief Valve - Clean
3500B Engines Engine Oil Filter Housing - Remove
3064 and 3066 Engines for Caterpillar Built Machines Cylinder Liner - Remove
3500B Engines Engine Oil Pump - Install
3500B Engines Engine Oil Pump - Assemble
3064 and 3066 Engines for Caterpillar Built Machines Inlet Manifold - Install
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Alternator and Regulator
994D Wheel Loader Engine Supplement Radiator Guard, Radiator, and Oil Coolers - Install
994D Wheel Loader Engine Supplement Radiator Guard, Radiator, and Oil Coolers - Remove
3500B Engines Engine Oil Pump - Disassemble
515 and 525 Wheel SkiddersMachine Systems Steering Wheel - Remove and Install
613C Series II Wheel Tractor-Scraper Air System and Brakes Parking Brake - Test and Adjust
3500B Engines Engine Oil Filter Housing - Install
3500B Engines Engine Oil Filter Base - Remove - Spin-on Filters
545 Wheel Skidder Machine Systems Steering Cylinder - Remove and Install
613C Series II Wheel Tractor-Scraper Transmission Breather - Clean
3500B Engines Engine Oil Filter Base - Disassemble - Spin-on Filters
3500B Engines Engine Oil Filter Base - Assemble - Spin-on Filters
613C Series II Wheel Tractor-Scraper Transmission Oil - Change
613C Series II Wheel Tractor-Scraper Transmission Oil Filter and Magnetic Screen - Replace/Clean
3500B Engines Engine Oil Filter Base - Install - Spin-on Filters
Installation of New 123-4610 Conversion Kit for the Flywheel Clutch{1007, 1156} Installation of New 123-4610 Conversion Kit for the Flywheel Clutch{1007, 1156}
994D Wheel Loader Power Train Speed Sensor (Torque Converter Output) - Remove and Install