Ejector Carrier Rollers - Check/Adjust
Park the machine on level ground. Lower the bowl.
The ejector carrier rollers are located at the rear base of the ejector. There are 2 ejector carrier rollers. These rollers prevent the ejector from contacting the floor of the bowl.
Check the adjustment for the ejector carrier rollers. The ejector carrier rollers are correctly adjusted if the ejector does not contact the bottom of the bowl.
Show/hide table
| |
| Illustration 1 | g00584096 |
- Loosen the roller shaft clamping bolt.
- Move the eccentric roller shaft to a position that allows the ejector to pass over the bottom of the bowl.
- Tighten the roller shaft clamping bolt.
- Repeat Step 1 through Step 3 in order to adjust the other ejector carrier roller.
- Start the engine. Move the ejector forward and backward. Stop the engine.
- Check for drag between the ejector and the bottom of the bowl. Repeat the adjustment procedure, if necessary.
Caterpillar Information System:
994D Wheel Loader Machine System Gear Pump (Pilot and Implement Oil Cooler) - Disassemble
D6R Series II Track-Type Tractor Hydraulic System Counterbalance Valve
992G, 992K, 994, 994D and 994F Wheel Loaders VIMS Loader Payload System Component Description
D6R Series II Track-Type Tractor Hydraulic System Steering Control Valve
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Auxiliary Water Pump
Installation of Multishank Ripper 7PP{6310, 6315, 6316} Installation of Multishank Ripper 7PP{6310, 6315, 6316}
613C Series II Wheel Tractor-Scraper Cooling System Coolant (ELC) - Change
545 Wheel Skidder Engine Supplement Radiator - Remove and Install
963C Track-Type Loader Power Train Hydraulic Drive Pump - Install
545 Wheel Skidder Engine Supplement Turbocharger - Remove and Install
938G Wheel Loader and IT38G Integrated Toolcarrier Hydraulic Tank Breaker Relief Valve - Clean
RA1.2, R1.4, R2.0, R2.2, R2.5, R2.7, R3.0, R4.5 and R5.5 Series Reduction Starting Motors Starting Motor - Troubleshoot
613C Series II Wheel Tractor-Scraper Cooling System Water Temperature Regulator - Replace
615C Series II Wheel Tractor-Scraper Ejector Carrier Rollers - Inspect/Pack/Replace
615C Series II Wheel Tractor-Scraper Ejector Guide Rollers - Check/Adjust
3034 Engine for Caterpillar Built Machines Coolant Temperature Switch - Remove and Install
3054 and 3056 Industrial and Generator Set Engines Air Inlet Elbow
613C Series II Wheel Tractor-Scraper Cutting Edges and End Bits - Inspect/Replace
615C Series II Wheel Tractor-Scraper Ejector Guide Rollers - Inspect/Replace
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Cylinder Head
D8R Series II Track-Type Tractor Radiator Guard Pin Joint - Inspect
615C Series II Wheel Tractor-Scraper Ejector Support Rollers - Check/Adjust
615C Series II Wheel Tractor-Scraper Ejector Support Rollers - Inspect/Replace
3034 Engine for Caterpillar Built Machines Rocker Shaft and Pushrod - Remove