Transmission Hydraulic Control Linkage - Adjust
Show/hide table
 | |
| Illustration 1 | g00577753 |
Transmission Control Linkage (1) Spool (2) Nut (3) Rod (4) Bolt (5) End (6) Cam (7) Detent (8) Nut (9) Rod (10) Nut (11) Spool | |
Show/hide table
 |
Personal injury or death can result from sudden machine movement. Accidental movement of controls while the engine is running can cause sudden machine movement. Do not make any adjustments to the control linkage with the engine running unless required. Allow only approved personnel on the machine. Keep other personnel off the machine and in clear view of the service personnel. |
 |
- Remove the covers from the cam housing and the control valve housing.
- Loosen the nut (8) and remove the bolt (4) .
- Move the cam (6) until the detent (7) is in the FOURTH speed position.
- Loosen the nuts (2) and (10). Make adjustments to the rods (3) and (9) until the spools (1) and (11) are even with face (x) of the valve body. Tighten the nuts (2) and (10) .
- Move the transmission control lever in the operator's compartment to the FOURTH speed position.
- Make an adjustment to the end (5) until the bolt (4) can be installed in the cam (6). Tighten the nut (8) .
- Install the covers.
Caterpillar Information System:
994D Wheel Loader Engine Supplement Air Starting Motor - Remove and Install
3034 Engine for Caterpillar Built Machines Crankshaft Front Seal - Remove
3034 Engine for Caterpillar Built Machines Crankshaft Pulley - Remove and Install
966G and 972G Wheel Loaders Equipment Lowering with Engine Stopped
3034 Engine for Caterpillar Built Machines Electric Starting Motor - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Injection Actuation Pressure Control Valve - Assemble
D7R Series II Track-Type Tractor Hydraulic System Implement Control Valve
988G Wheel Loader Bucket Wear Plates - Inspect/Replace
3034 Engine for Caterpillar Built Machines Alternator - Remove and Install
611 Wheel Tractor-Scraper Wheel Tractor-Scraper Power Train Visual Inspection
3176C and 3196 Engines for Caterpillar Built Machines Air Inlet and Exhaust System - Inspect
D6R Track-Type Tractor Safety Signs and Labels
D6R Series II Track-Type Tractor Hydraulic System Main Relief Valve
615C Series II Wheel Tractor-Scraper Parking and Secondary Brake Control
D11T Track-Type Tractor Hydraulic System Hydraulic Pump
3406E On-Highway Engine Pistons and Connecting Rods - Remove
613C Series II Wheel Tractor-Scraper Transmission Control
613C Series II Wheel Tractor-Scraper Transmission Neutral Lock Control
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Remove
D6R Series II Track-Type Tractor Hydraulic System Oil Cooler and Bypass Valve
963C Track-Type Loader Power Train Track Roller Frame - Install
615C Series II Wheel Tractor-Scraper Transmission Control
613C Series II Wheel Tractor-Scraper Bowl Control
613C Series II Wheel Tractor-Scraper Ejector Control