Electric Starting Motor - Remove and Install
Removal Procedure
Show/hide table
Disconnect batteries before performance of any service work. |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Disconnect all electrical connections to the electric starting motor before proceeding. Mark all connections for later installation.
- Remove three nuts (1) and cable (2) .
Show/hide table
Illustration 1 | g00577682 |
- Remove electric starting motor (3) from the engine.
Installation procedure
- Put electric starting motor (3) in position on the engine.
Show/hide table
Illustration 2 | g00577682 |
- Install cable (2) and three nuts (1) .
- Tighten the three nuts to a torque of 44 N·m (32 lb ft).
Note: Reconnect all electrical connections to the electric starting motor before you operate the engine.
Caterpillar Information System:
3408E and 3412E Engines for Caterpillar Built Machines Injection Actuation Pressure Control Valve - Assemble
D7R Series II Track-Type Tractor Hydraulic System Implement Control Valve
988G Wheel Loader Bucket Wear Plates - Inspect/Replace
3034 Engine for Caterpillar Built Machines Alternator - Remove and Install
611 Wheel Tractor-Scraper Wheel Tractor-Scraper Power Train Visual Inspection
3176C and 3196 Engines for Caterpillar Built Machines Air Inlet and Exhaust System - Inspect
D6R Track-Type Tractor Safety Signs and Labels
3408E and 3412E Engines for Caterpillar Built Machines Injection Actuation Pressure Control Valve - Disassemble
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Fuel Injection Control Linkage
3408E and 3412E Engines for Caterpillar Built Machines Injection Actuation Pressure Control Valve - Install
994D Wheel Loader Engine Supplement Air Cleaner - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Injection Actuation Pressure Control Valve - Remove
966G and 972G Wheel Loaders Equipment Lowering with Engine Stopped
3034 Engine for Caterpillar Built Machines Crankshaft Pulley - Remove and Install
3034 Engine for Caterpillar Built Machines Crankshaft Front Seal - Remove
994D Wheel Loader Engine Supplement Air Starting Motor - Remove and Install
611 Wheel Tractor-Scraper Wheel Tractor-Scraper Power Train Transmission Hydraulic Control Linkage - Adjust
D6R Series II Track-Type Tractor Hydraulic System Main Relief Valve
615C Series II Wheel Tractor-Scraper Parking and Secondary Brake Control
D11T Track-Type Tractor Hydraulic System Hydraulic Pump
3406E On-Highway Engine Pistons and Connecting Rods - Remove
613C Series II Wheel Tractor-Scraper Transmission Control
613C Series II Wheel Tractor-Scraper Transmission Neutral Lock Control
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Remove