Crankshaft Rear Seal - Remove
Removal Procedure
Start By:
- Remove the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove bolts (3) and backplate (2) from the rear of the cylinder block.
Show/hide table
Illustration 1 | g00847841 |
- Remove crankshaft rear seal (1) from the cylinder block.
Caterpillar Information System:
613C Series II Wheel Tractor-Scraper Transmission Neutral Lock Control
613C Series II Wheel Tractor-Scraper Transmission Control
3406E On-Highway Engine Pistons and Connecting Rods - Remove
D11T Track-Type Tractor Hydraulic System Hydraulic Pump
615C Series II Wheel Tractor-Scraper Parking and Secondary Brake Control
D6R Series II Track-Type Tractor Hydraulic System Main Relief Valve
611 Wheel Tractor-Scraper Wheel Tractor-Scraper Power Train Transmission Hydraulic Control Linkage - Adjust
994D Wheel Loader Engine Supplement Air Starting Motor - Remove and Install
3034 Engine for Caterpillar Built Machines Crankshaft Front Seal - Remove
3034 Engine for Caterpillar Built Machines Crankshaft Pulley - Remove and Install
966G and 972G Wheel Loaders Equipment Lowering with Engine Stopped
3034 Engine for Caterpillar Built Machines Electric Starting Motor - Remove and Install
D6R Series II Track-Type Tractor Hydraulic System Oil Cooler and Bypass Valve
963C Track-Type Loader Power Train Track Roller Frame - Install
615C Series II Wheel Tractor-Scraper Transmission Control
613C Series II Wheel Tractor-Scraper Bowl Control
613C Series II Wheel Tractor-Scraper Ejector Control
613C Series II Wheel Tractor-Scraper Elevator Control
615C Series II Wheel Tractor-Scraper Transmission Neutral Lock Control
3408E and 3412E Engines for Caterpillar Built Machines Pistons and Connecting Rods - Install
3408E and 3412E Engines for Caterpillar Built Machines Turbocharger - Remove
3034 Engine for Caterpillar Built Machines Crankshaft Front Seal - Install
3408E and 3412E Engines for Caterpillar Built Machines Air in Fuel - Test
963C Track-Type Loader Power Train Equalizer Bar - Install