Electronic Control Module - Remove and Install
Removal Procedure
- Remove nut (1), the washer, and clip (2) .
Show/hide table
Illustration 1 | g01023070 |
- Loosen bolt (7) until harness assembly (8) can be disconnected. Disconnect harness assembly (8) .
- Remove nuts (6) and the washers. Move hose assembly (5) out of the way. Remove plate (3) .
- Remove bolt (9) and the washer. Remove studs (4) and the washers. Remove the electronic control module from the engine.
Installation procedure
- Position the electronic control module on the engine and install studs (4) and the washers.
Show/hide table
Illustration 2 | g01023070 |
- Install bolt (9) and the washer.
- Install hose assembly (5) and plate (3). Install nuts (6) .
- Connect harness assembly (8). Tighten bolt (7) to a torque of 6 ± 1 N·m (53 ± 9 lb in).
- Install clip (2), the washer, and nut (1) .
Caterpillar Information System:
D11R Track-Type Tractor Power Train Track Idler
D11R Track-Type Tractor Power Train Equalizer Bar
3046 Engine For Caterpillar Built Machines Fuel Injection Pump Housing and Governor - Install
D11R Track-Type Tractor Power Train Track Roller Frame
D11R Track-Type Tractor Power Train Undercarriage
515 Wheel Skidder and 525 Wheel Skidder Transmission and Grapple Electronic Control System Electrical General Information
994D Wheel Loader Steering System Articulated Hitch Group - Adjust
D11R Track-Type Tractor Power Train Final Drive
D11R Track-Type Tractor Power Train Steering and Brake Control Valve
D9R Track-Type Tractor Fire Prevention and Explosion Prevention
D11R Track-Type Tractor Power Train Steering Clutch and Brake
D11R Track-Type Tractor Power Train Transfer and Bevel Gears
D11R Track-Type Tractor Power Train Tracks
611 Wheel Tractor-Scraper Transmission Oil - Change
D11R Track-Type Tractor Power Train Pivot Shaft
D11R Track-Type Tractor Power Train Track Roller
994D Wheel Loader Machine System Piston Pump (Implement) - Remove
611 Wheel Tractor-Scraper Transmission Breather - Clean
3114, 3116 and 3126 MUI Engine Governors Governor Limiting Circuit (Types I, II, III, and IV)
963B Track-Type Loader Electronic Monitoring System (EMS)
992G, 992K, 994, 994D and 994F Wheel Loaders VIMS Loader Payload System Basic Operation
3046 Engine For Caterpillar Built Machines Fuel Transfer Pump - Remove
988F and 988F Series II Wheel Loaders Power Train Trunnion Support (Oscillating Axle, Front) - Remove and Install
824G , 825G and 826G Landfill Compactor Fuel Tank Cap and Strainer - Clean