Tire and Rim (Rear) - Remove and Install
Removal Procedure
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
A     | 9U-7536     | Lift Stand (55 Ton)     | 2     |
4C-5809 | Electric Hydraulic Pump     | 1     |
Start By:
- Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
- Place wood block (1) between the rear axle housing and the frame. Repeat this step on the opposite side of the machine. This will prevent the rear axle housing from oscillating.
Show/hide table
Illustration 1 | g00445523 |
- Position Tooling (A) under the rear loader frame, as shown.
Show/hide table
Illustration 2 | g00445524 |
- Use Tooling (A) to raise the rear of the machine so that the rear tires are off the ground.
- Fasten suitable lifting slings and a hoist to the tire, as shown. Remove 20 bolts (2) .
- Use the hoist to remove the tire and the rim. The combined weight of the tire and of the rim is 680 kg (1500 lb).
Installation Procedure
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
A     | 9U-7536     | Lift Stand (55 Ton)     | 2     |
4C-5809 | Electric Hydraulic Pump     | 1     |
- Use suitable lifting slings and a hoist to position the tire and the rim, as shown. The combined weight of the tire and of the rim is 680 kg (1500 lb).
Show/hide table
Illustration 3 | g00445524 |
- Install 20 bolts (2). The initial torque for bolts (2) is 570 ± 80 N·m (420 ± 60 lb ft). Then turn bolts (2) by an additional 60 ± 5 degrees.
- Lower the machine. Remove Tooling (A) .
- Remove wood blocks (1) from both sides of the machine.
Show/hide table
Illustration 4 | g00445523 |
End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
Caterpillar Information System:
D7R Track-Type Tractor Power Train Recoil Group
902 and 906 Wheel Loaders Tire and Rim
D7R Track-Type Tractor Power Train Equalizer Bar
966G and 972G Wheel Loaders Power Train Tire and Rim (Front) - Remove and Install
994D Wheel Loader Braking System Brake Control (Parking Brake)
631E Series II Wheel Tractor-Scrapers Wheel Bearing Oil - Change
D7R Track-Type Tractor Power Train Brake Control Valve
D7R Track-Type Tractor Power Train Steering Differential and Brakes
631E Series II Wheel Tractor-Scrapers Window Wiper - Inspect/Replace
994D Wheel Loader Braking System Pressure Switch (Steering and Brake Filter)
928G Wheel Loader Circuit Breakers and Fuses - Reset/Replace
627F Wheel Tractor-Scraper Window Washer Reservoir - Fill
D7R Track-Type Tractor Power Train Pivot Shaft
D5M Track-Type Tractor Caterpillar Monitoring System
902 and 906 Wheel Loaders Fuel Tank
D7R Track-Type Tractor Power Train Track Roller Frames
966G and 972G Wheel Loaders Power Train NoSPIN Differential - Assemble
D7R Track-Type Tractor Power Train Idlers (Track)
902 and 906 Compact Wheel Loaders Hydraulic System Bank Valve (Three)
D7R Track-Type Tractor Power Train Track Roller
D8R Track-Type Tractor Seat
D7R Track-Type Tractor Power Train Track Carrier Roller
994D Wheel Loader Braking System Brake Control
D7R Track-Type Tractor Power Train Tracks