Fuel Transfer Pump - Remove
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Turn the fuel shutoff valve to the “OFF” position.
- Disconnect the fuel supply line at the fuel transfer pump.
Show/hide table
Illustration 1 g01075935 - Disconnect tube assembly (4).
- Remove bolts (3).
- Remove fuel transfer pump (1) from front housing (5).
- Remove O-ring seal (2) from the fuel transfer pump.
Caterpillar Information System:
G3516B Engines Location of Components
C15 On-highway Engines Fuel Priming Pump - Remove and Install
G3600 Engines Speed Sensor
C7 Urban Transit Bus Engines Cooling System Coolant (DEAC) - Change
C27 and C32 Industrial and Petroleum Engines Electronic Unit Injector Wiring
C27 and C32 Engines for Caterpillar Built Machines Electronic Unit Injector Mechanism
2004/09/01 An Improved Auxiliary Water Pump is Introduced {1371}
3406E and 3456 Industrial Engines Air Shutoff Solenoid
C9.3 Engine for Caterpillar Built Machines Piston Cooling Jet
3406E and 3456 Generator Set Engines Poor Acceleration or Response
C9 Marine Engines and C9 Marine Generator Sets Electric Starting Motor
3406E Truck Engines Crankshaft Seals
C15 On-highway Engines Fuel Transfer Pump - Install
C11 and C13 Petroleum Engines Lubrication System
G3516B Engines Generator Output Power Readings Do Not Match
C15 On-highway Engines Electronic Unit Injector - Remove
G3516B Engines Generator Output Power Sensor
C15 and C18 Generator Set Engines Electronic Unit Injector Sleeve - Remove
C15 and C18 Industrial Engines Electronic Unit Injector Sleeve - Install
C9 Marine Generator Set Engines Basic Engine
C15 and C18 Industrial Engines Water Lines
G3516B Engines Generator Output Power Sensor - Calibrate
3406E and 3456 Generator Set Engines Crankshaft Rear Seal - Install
C9 Marine Generator Set Engines Finding Top Center Position for No. 1 Piston