Piston Cooling Jet
Show/hide table
Illustration 1 | g00930372 |
The piston cooling jet must be checked for the location of the stream of oil. Insert a drill rod with a diameter of
Use the following dimensions in order to locate point (F):
- Dimension (A) ...
71.88 ± 0.25 mm (2.830 ± 0.010 inch) - Dimension (B) ...
120.00 ± 0.25 mm (4.724 ± 0.010 inch) - Dimension (C) ...
42.2 mm (1.66 inch) - Dimension (D) ...
16.07 ± 0.25 mm (0.633 ± 0.010 inch) - Dimension (E) ...
120.00 ± 0.25 mm (4.724 ± 0.010 inch) - Dimension (B) ...
Caterpillar Information System:
3406E and 3456 Generator Set Engines Poor Acceleration or Response
C9 Marine Engines and C9 Marine Generator Sets Electric Starting Motor
3406E Truck Engines Crankshaft Seals
3406E Truck Engines Crankshaft
C11 and C13 Engines for Caterpillar Built Machines Vibration Damper - Check
C9 Marine Engines and C9 Marine Generator Sets Flywheel Housing
3406E, C-10 and C-12 On-highway Engines 0171-03 Ambient Air Temperature voltage high
325D and 329D Excavators Stopping the Machine
3406E and 3456 Generator Set Engines Air Starting System
C15 and C18 Industrial Engines Cooling System
C15 and C18 Industrial Engines Electronic Control System Components
C15 and C18 Petroleum Engines General Information
3406E and 3456 Industrial Engines Air Shutoff Solenoid
2004/09/01 An Improved Auxiliary Water Pump is Introduced {1371}
C27 and C32 Engines for Caterpillar Built Machines Electronic Unit Injector Mechanism
C27 and C32 Industrial and Petroleum Engines Electronic Unit Injector Wiring
C7 Urban Transit Bus Engines Cooling System Coolant (DEAC) - Change
G3600 Engines Speed Sensor
C15 On-highway Engines Fuel Priming Pump - Remove and Install
G3516B Engines Location of Components
C15 On-highway Engines Fuel Transfer Pump - Remove
C15 On-highway Engines Fuel Transfer Pump - Install
C11 and C13 Petroleum Engines Lubrication System
G3516B Engines Generator Output Power Readings Do Not Match