Crankshaft
Show/hide table
Illustration 1 | g00955608 |
Note: For the correct procedure on measuring for a bent crankshaft, refer to the Guideline for Reusable Parts, SEBF8054, "Procedure to Measure and Straighten Crankshafts".
(1) The length of the dowel from the surface of the crankshaft ... 4.1 ± 0.5 mm (0.16 ± 0.02 inch)
(2) The length of the dowel from the surface of the crankshaft ... 6.4 mm (0.25 inch)
(3) Main bearing journal
(4) Connecting rod bearing journal
Refer to Specifications, "Connecting Rod Bearing Journal" and Specifications, "Main Bearing Journal" for more information about the crankshaft journals.
(5) Crankshaft end play
- The end play for the crankshaft (new) ... 0.15 to 0.55 mm (0.007 to 0.022 inch)
- The maximum permissible end play with used bearings ... 0.89 mm (0.035 inch)
(6) Timing gear
Note: The timing mark "V" must be oriented to the front of the crankshaft when the gear is installed.
Caterpillar Information System:
C11 and C13 Engines for Caterpillar Built Machines Vibration Damper - Check
C9 Marine Engines and C9 Marine Generator Sets Flywheel Housing
3406E, C-10 and C-12 On-highway Engines 0171-03 Ambient Air Temperature voltage high
325D and 329D Excavators Stopping the Machine
3406E and 3456 Generator Set Engines Air Starting System
C15 and C18 Industrial Engines Cooling System
C15 and C18 Industrial Engines Electronic Control System Components
C15 and C18 Petroleum Engines General Information
G3516B Engines Inspecting Electrical Connectors
ES12F, UPS 1000S and UPS 1200S Uninterruptible Power Supplys Status Messages
3176C and 3196 Engines for Caterpillar Built Machines Speed/Timing Sensor
C15 and C18 Industrial Engines Turbocharger
3406E Truck Engines Crankshaft Seals
C9 Marine Engines and C9 Marine Generator Sets Electric Starting Motor
3406E and 3456 Generator Set Engines Poor Acceleration or Response
C9.3 Engine for Caterpillar Built Machines Piston Cooling Jet
3406E and 3456 Industrial Engines Air Shutoff Solenoid
2004/09/01 An Improved Auxiliary Water Pump is Introduced {1371}
C27 and C32 Engines for Caterpillar Built Machines Electronic Unit Injector Mechanism
C27 and C32 Industrial and Petroleum Engines Electronic Unit Injector Wiring
C7 Urban Transit Bus Engines Cooling System Coolant (DEAC) - Change
G3600 Engines Speed Sensor
C15 On-highway Engines Fuel Priming Pump - Remove and Install
G3516B Engines Location of Components