Electric Starting Motor
Show/hide table
Illustration 1 | g01093287 |
Show/hide table
Illustration 2 | g01093288 |
When the electric starting motor is viewed from the drive end, the motor rotates in the following direction. ... Clockwise
No load conditions at 25 °C (77 °F)
- Speed ... 6900 ± 1800 rpm
- Current draw ... 127.5 ± 27.5 amp
- Voltage ... 11 V
- Current draw ... 127.5 ± 27.5 amp
(1) Battery terminal nut
-
A maximum of three cable or wire terminals should be between the nuts.
- Torque ... 30.5 ± 3.5 N·m (22 ± 3 lb ft)
(2) Ground terminal nut
- Torque ... 30.5 ± 3.5 N·m (22 ± 3 lb ft)
(3) Ground terminal nut
- Torque ... 2.25 ± 0.25 N·m (20 ± 2 lb in)
(4) Switch terminal nut
- Torque ... 2.25 ± 0.25 N·m (20 ± 2 lb in)
(5) Motor terminal nut
- Torque ... 30.5 ± 3.5 N·m (22 ± 3 lb ft)
(6) Nut for the motor frame
- Torque ... 8 ± 3 N·m (70 ± 24 lb in)
Clearance between the pinion and the housing ... 9.1 mm (0.36 inch)
Solenoid
Current draw at 10 V and 25 °C (77 °F)
- Pull-in windings ... 92.5 ± 7.5 Amp
- Hold-in windings ... 23 Amp maximum
Caterpillar Information System:
3406E Truck Engines Crankshaft Seals
3406E Truck Engines Crankshaft
C11 and C13 Engines for Caterpillar Built Machines Vibration Damper - Check
C9 Marine Engines and C9 Marine Generator Sets Flywheel Housing
3406E, C-10 and C-12 On-highway Engines 0171-03 Ambient Air Temperature voltage high
325D and 329D Excavators Stopping the Machine
3406E and 3456 Generator Set Engines Air Starting System
C15 and C18 Industrial Engines Cooling System
C15 and C18 Industrial Engines Electronic Control System Components
C15 and C18 Petroleum Engines General Information
G3516B Engines Inspecting Electrical Connectors
ES12F, UPS 1000S and UPS 1200S Uninterruptible Power Supplys Status Messages
3406E and 3456 Generator Set Engines Poor Acceleration or Response
C9.3 Engine for Caterpillar Built Machines Piston Cooling Jet
3406E and 3456 Industrial Engines Air Shutoff Solenoid
2004/09/01 An Improved Auxiliary Water Pump is Introduced {1371}
C27 and C32 Engines for Caterpillar Built Machines Electronic Unit Injector Mechanism
C27 and C32 Industrial and Petroleum Engines Electronic Unit Injector Wiring
C7 Urban Transit Bus Engines Cooling System Coolant (DEAC) - Change
G3600 Engines Speed Sensor
C15 On-highway Engines Fuel Priming Pump - Remove and Install
G3516B Engines Location of Components
C15 On-highway Engines Fuel Transfer Pump - Remove
C15 On-highway Engines Fuel Transfer Pump - Install